Water solenoid is leaking cold water
SOURCE: front load washer leak
This could be the rubber seal or the door lock. If the door lock is not pulling it tightly closed then it needs to be replaced. Check the seal really closely and make sure there are not cracks and it does not look deformed
SOURCE: My LG TROMM (WM1812CW) does
This code means that something is blocking either the water drain pipe,
pump filter or the pump itself. I had the same problem and removing the
filter (as recommended by LG) did not help. It turned out I had a piece
of debris stuck in the pump propeller itself and consequently the water
would not drain and the wash would not finish, prompting the error.
This is what I did to fix the problem.
1. I removed the cover on the left bottom corner and the removed the filter and unhooked the little rubber tube (drain).
2. I removed the pump cover (lower left corner of the washing machine) and unscrewed 3 screws holding the pump from the front.
3. I disconnected the power supply and removed the back panel (attached with 4 screws)
4. Disconnected the two hoses (one black, one gray) from the pump.
5. Disconnected the power supply to the pump (I had to cut a plastic
tie holding the connector in place in order to bring the connector
closer so I can disconnect it).
6. Removed the pump by pressing a little tab that was holding it from the back.
7. Once I removed the pump from the washing machine, I took three
screws out of the pump motor, gaining access to the propeller. This is
where I found a little piece of plastic. Apparently propeller couldn't
spin because of that obstruction.
8. I put the pump back together and attached the hoses. This is easier
to do when you have the pump closer to the back opening of the washing
machine.
9. I then connected the pump power supply connector, locked the pump back in its place and replaced the screws.
The total repair took less than 45 minutes. The hardest part was to
remove and replace the drain tube springs, because I did not have the
right pliers (You need decent size pliers or plenty of strength in your
hands to squeeze the metal bands).
The tools you need for this repair are:
a philips and flat screwdrivers, large pliers and a sharp knife (to cut a plastic tie)
SOURCE: Front bottom leak from my LG TROMM HE Washer
please rate my suggestion...
SOURCE: LG WM2487 front load washer spews suds out of port on rear.
You are likely using too much detergent or the detergent is not high-efficiency detergent. Change detergents and/or lower amount and this problem should go away.
The water port on the back allows air inside the tub to escape. However, if the wrong type or quantity of detergent are used, excess suds will flow from this port.
698 views
Usually answered in minutes!
×