Question about Kodak EASYSHARE 5300 All-In-One InkJet Printer

1 Answer

How to remove printer tray - Kodak EASYSHARE 5300 All-In-One InkJet Printer

Posted by Anonymous on

  • Anonymous Feb 12, 2016

    How to remove printer tray from kodak 5300

×

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Kodak Master
  • 66,098 Answers

Most just pull out .

Posted on Feb 12, 2016

  • Barbara Williams
    Barbara Williams Jan 31, 2017

    The photo tray on the Kodak 5300 has slipped out of alignment therefore The whole paper tray ahs to be removed to get it back into the grooves. It doesn't just slide out.

×

Ad

1 Suggested Answer

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Says paper out or paper jam which nither are happening


  1. Unplug the power cord.
  2. Check to see if the print carriage moves freely from one side of the printer to the other. ...
  3. Remove the print cartridges. ...
  4. Gently move the print cartridge to the far right of the printer.
  5. Remove the paper from the paper In tray, but do not remove the drawer.
  6. Step one: Clear the paper jam from the output tray
    1. Carefully remove any loose paper from the output tray.
    2. Check the rollers in the output tray for jammed paper.
    3. Use a flashlight to see the rollers in the printer.
      Figure : Use a flashlight
    4. Gently remove any jammed paper or bits of torn paper from the output tray rollers. Use both hands to pull out any whole sheets of paper to avoid tearing them.
    5. Remove any bits of paper or torn pieces of paper from the output tray rollers.
    Step two: Clear the jam from the input tray
    1. Press the Power button to turn off the printer.
    2. Disconnect the power cord from the rear of the printer.
    3. Remove all paper from the output tray.
    4. Raise the output tray.
      Figure : Raise the output tray
    5. Grasp any jammed paper in the input tray with both hands, and then pull the paper slowly but firmly toward you to remove it.
      CAUTION: Remove paper from the tray as carefully as possible. If any torn pieces of paper remain inside the printer, more paper jams are likely to occur, and this could damage the print mechanism.
    6. Lower the output tray.
    7. Reconnect the power cord to the rear of the printer.
    8. Press the Power button to turn off the printer.
    If you are not satisfied with this answer then for detail answer please read here > http://www.brotherprintersupportnumber.com

Feb 14, 2016 | Epson WorkForce Pro WP-4540 Color Ink-jet

1 Answer

How remove feeder tray from 6600


Hi Ed Walsh,

When you say feeder tray, are you speaking of the document feeder tray, or the paper input tray? The document feeder tray is not customer replaceable so it will not be removable. The input paper tray is however removable. Perhaps you will find the support page for your Officejet 6600 helpful:
HP Officejet 6600 All in One Printer H711a H711g How to

I hope this helps.
I work on behalf of HP.



:)

Jul 14, 2015 | HP OfficeJet 6600 e-All-In-One Inkjet...

1 Answer

How do I put the paper tray back into my HP LaserJet P3015 printer


Make sure that you did not lower the duplex tray. Look into the printer where the paper tray goes and make sure the path is clear. The duplex tray is dropped by pushing on a green lever on the left front of the duplex tray. Simply push the tray up until if clicks and locks in place. This is the only reason I have run into with clients as to why they cannot insert the paper tray.

Sep 13, 2014 | HP Laserjet P3015X Printer

1 Answer

Dell 5110cn printer Tray Detached error 024-946


Cycle power on the Printer.
  1. Turn the printer off.
  2. Wait 10 seconds.
  3. Turn the printer on.
  4. Determine if the issue still occurs.

If tray 1 is being used:
  1. Remove and reseat the tray.
    To remove and reseat the tray, perform the following steps:
    1. Pull the 250-sheet tray out of the printer until it stops.
    2. Hold the tray with both hands, lift the front slightly, and remove it from the printer (Figure 1).
      250tray1.jpg
      Figure 1: Removing the Tray
Re-insert the paper tray into the printer and push it until it stops (Figure 2).
250tray3.jpg
Figure 2: Reinstalling the Tray
Run diagnostics on the tray 1 paper size switch on the Dell 5110cn printer


http://www.smoothprinterservice.com/

Dec 18, 2012 | Dell 5110cn Laser Printer

1 Answer

Cannot clear error code 3523 for Kodak ESP 9200 Series all in one printer. Have followed all instructions per Kodak online


Had the same problem error 3523 that would not clear. Tried Kodak support with no results so took matters into my own hands.

Noticed the top tray seemed jammed into the printer. Tried pulling it out but it seemed locked. Flipped the printer over, removed 8 screws, 4 metal plates.

Removed bottom tray, set aside. Remove 3 screws for plastic bracket that holds top tray. Move bracket over, be careful not to damage wires. Remove top tray and reinstall so that it is in extended position. There is two notched in the side of the top tray. Extend so that catch is in back notch.

Reassemble everything in reverse order. Take care that the top tray does not slide into the printer when you turn the printer over. It did for me the first time that the tray jammed again.

Replug everything and startup the printer with top tray extended past bottom tray. The printer will tell you that top tray is jammed, push top tray flush with bottom tray.

Printer now works. Don't know why tray jams in the first place but this solution can keep you from scrapping printer or paying for service.

Very disappointed with Kodak printer. Obviously printers were not their core business and they paid a sub-contractor to build these products for them. My next printer will be an HP.

Jul 24, 2011 | Kodak ESP5250 All-In-One InkJet Printer

1 Answer

Tell me please hp laserjet printer 2420 paper tray setting


    1. Remove the packing material from the printer.
      1. Remove the all orange tape from the outside of the printer.
      c00318773.gif
    • Remove orange tape from paper tray 2. c00318774.gif
    • Remove the orange packing tape from inside paper tray 3. c00318775.gif
    • Remove the spacer from inside the print cartridge area. c00318776.gif
    1. Load all paper trays.
      1. Pull the paper trays completely out of the printer.
      c00318777.gif
    2. Press the blue tab on the rear paper length guide and adjust the rear guide so that the pointer matches the size of the paper to be loaded. c00318778.gif
    3. Move the side width guides outward to match the desired paper size. c00318779.gif
    4. Add the media to the paper trays, make sure that it is flat in the tray at all four corners. Keep the media below the height tabs on the sides and rear of the tray. Push down on the metal lift plate to lock it in place. c00318780.gif
    5. Slide the trays back into the printer. c00318781.gif
    6. Install the print cartridge.
      1. Remove the print cartridge from the packaging.
      c00318782.gif
    7. Rock the print cartridge back and forth several times to "mix" the toner. c00318783.gif
    8. Pull the sealing tape from the end of the print cartridge to remove the entire length of the tape. c00318784.gif
    9. Open the top cover. c00318785.gif
    10. Slide the print cartridge into the unit. c00318786.gif
    11. Close the print cartridge door. c00318787.gif
    12. Connect the LAN cable (optional). (HP LaserJet 2420n, 2420dn, 2430tn, and 2430dtn models only) c00318788.gif
    13. Connect the power. c00318789.gif

    Jan 13, 2011 | HP LaserJet 2420 Printer

    1 Answer

    I changed the printer cartages I put the paper on the tray and it took allthe paper and jamed' How do I get the paper out?


    You can follow these procedure to clear the Jammed on your printer.

    1.Remove the paper tray (Installing and removing the paper tray).
    2.Disconnect the power from the printer dock for 5 seconds, then reconnect the power.
    Carefully remove the paper if it does not automatically eject.
    IMPORTANT:Check the paper slot on the back of the printer dock for jammed paper:
    3.Remove the paper supply from the paper tray. Carefully "fan" the paper to keep the sheets from sticking together.
    4.Reload the paper tray. Do not exceed the fill line.
    5.Re-install the paper tray, then press to resume printing.

    You can also check this link for other troubleshooting tips that you can do if you have problem with the printer, just click HERE.

    Nov 24, 2010 | Kodak ESP 3 Multifunction Printer/ Copier/...

    1 Answer

    How to remove a paper jam from the vivera paper tray


    1. Turn off the printer.
    2. Inspect the location or tray the printed paper ejects to. If the stuck paper is visible manually remove it.*
    3. Remove all paper trays and any paper that may be stuck between the tray and the printer. If the stuck paper is visible manually remove it.*
    4. Open the printer door that allows you access to the printer ink cartridges or toner and look for any stuck paper. If the stuck paper is visible manually remove it.*
    5. Turn the printer back on. If you continue to receive a printer jam error try repeating the above steps again. If issue still persist and you see no paper that is stuck in the printer it's likely your printer is experiencing another hardware issue and i suggest contacting the printer manufacturer for additional assistance and/or repair.

    Jul 13, 2009 | HP Photosmart C7280 Laser Printer

    2 Answers

    Printer won't print


    60.2
    printer error
    The tray 2 lifter-motor is not functioning. 1 Turn the printer off and then on.
    2 If the error persists, turn the printer off.
    3 Verify that the tray 2 lifter wire-harness
    is full seated in its connector on the
    dc controller PCA (location J93).
    4 Replace the tray 2 lifter-driver
    assembly. See Tray 2 lifter-drive
    assembly.
    5 Replace the dc controller PCA. See
    Dc controller PCA.
    This is straight out of the manual.
    Tray 2 lifter-drive assembly
    1
    Remove the following assemblies:
    ● Rear accessory cover. See Accessory covers and the tray 2 extension door.
    ● Top cover. See Top cover.
    ● Right-side cover. See Right-side cover.
    ● Formatter cover. See Formatter cover
    ● Formatter. See Formatter assembly
    ● Paper-pickup drive assembly. See Paper-pickup drive assembly.
    2 Unplug the tray 2 lifter-drive assembly connector from the dc controller PCA (location J93) and
    the two flat cables (callout 1, locations J80, J81). Unweave the wire-harness from the cable
    guide (callout 2).
    NOTE You might have to remove additional wire-harnesses from the cable guide to gain
    access to the lifter-drive assembly wire-harness.
    Figure 6-51 Tray 2 lifter-drive assembly (1 of 3)
    Main assemblies 227
    3
    Unhook the tension spring (callout 3) at the lifter-drive assembly, remove one screw (callout 4),
    and then slide the support plate (callout 5) out of the printer.
    Figure 6-52 Tray 2 lifter-drive assembly (2 of 3)
    228 6
    4
    Rotate the top of the lifter-drive assembly away from the printer to remove it from the printer.
    NOTE You might have to remove some cable guides to easily remove the lifter-driver
    assembly.
    Figure 6-53 Tray 2 lifter-drive assembly (3 of 3)
    Main assemblies
    unfortunately i couldn't paste the pictures to help you.
    Assembly is the exact reverse of removal, Good Luck!

    Nov 20, 2008 | HP LaserJet 4250n Printer

    1 Answer

    Paper tray


    Remove the paper jam clear cover on the back side of the printer. Press the paper feeder inwards the printer.Now you should be able to remove the paper tray. Have a look on the position of the photo tray (cover of the tray) Is it well positioned or do you have to fix it?

    Nov 02, 2007 | Brother DCP-330C All-In-One InkJet Printer

    Not finding what you are looking for?
    Kodak EASYSHARE 5300 All-In-One InkJet Printer Logo

    Related Topics:

    167 people viewed this question

    Ask a Question

    Usually answered in minutes!

    Top Kodak Office Equipment & Supplies Experts

    Clive
    Clive

    Level 3 Expert

    4345 Answers

    Ekse

    Level 3 Expert

    13434 Answers

    Cindy Wells

    Level 3 Expert

    6063 Answers

    Are you a Kodak Office Equipment and Supply Expert? Answer questions, earn points and help others

    Answer questions

    Manuals & User Guides

    Loading...