Want fully spin out clothes - Whirlpool Ultimate Care II LSQ9564J Top Load Washer

check cogs under agitator

If the belt mechanism is either loose or slipped or that the belt is damaged or worn out it might not be able to spin with enough or spin at all then . If the belt is broken or fully off the rollers then it can't spin at all. A washer that won't spin is not washing. If it can not agitate clothes and then clothes don't get clean. Call a repair person to have a look at your washing machine to see what the issue is.

That's is how they are designed. They just tumble clothes thru minimum amount of water. That's how they are low water use and high efficiency. They rinse the same way. Then they fully spin on spin mode. So your machine is working properly as designed.

Older washers have an adjustable clutch for the spin cycle.
You would have to look up your model.

You may have a weak clutch. If you can stop the washer during spin by hand, that's what it is.

I am not sure if Bosch has a "load sensing" sensor, but I would start there else you may have a motor issue, or bad capacitor on your motor.

do not put heavy cloth load as too much cloth gets stuck in the spin.

There is either a problem with the drain or spin cycle. Before the spin cycly starts, ensure that the water drains fully. If it does, then it may either be the belt slipping or the timer malfunctioning. If there is water in the tub when it starts spinning, then you have a blockage in the drain line.

This sounds like a motor control board is faulty. Please load a couple of towels in the machine run it. Watch the machine as it goes through its' cycles.

1. Do the towels tumble when the machine is washing ?
2. When it begins to spin, does it spin one way at a fast pace or does it spin one way and then the other ?

Answering these two questions will help in troubleshooting your problem.

Always rule out first: Unsorted, too big or off balance load, too high or restricted drain, oversudsing or water not draining completely out before going into spin. Otherwise the brake could be not releasing fully or the clutch lining is worn. Pull the basket and transmission and check the basket drive.