To turn the beep sound off when system is set to armed

There is always the exit delay, however, you can arm it silently and with no entry delay. To arm silently, press Door and windows, press silent.
To arm without entry delay, press doors and windows twice. Press silent if also wanting no beeps.

This is a tough one, it sounds like the alarm is arming itself when you lock the door, the alarm system is arming , there is a way i think to cancel out the horn chrip, the only other thing is the door lock is bad or the alarm module is going bad. Did the horn always chrip or beep before and do you know if the alarm works?

Sounds like alarm module has failed. Call ford parts and ask if common failure, if so replace. You could disconnect the alarm module and see if the car starts.

If it is wireless, then one or more of the switches need a new battery. I suggest replace them all and mark the date inside the box. I assume that there is no yellow triangle showing on the alarm panel. Triangle is for no phone connection.

It sounds like your alarm is in valet. Open any dooor, press lock, unlock, lock. The LED light should go off and you should be able to arm the alarm with the chirps active.

Hi, try and see if the user has been switched from car 1 to car 2 press and hold f for 3 seconds or until the remote beeps and the lock and or unlock leds turn on. car 1 will be 1 beep and armed led on. car 2 will be 2 beeps and arm and disarm leds on. if you press the f button while the leds are still lit then you can change to car 1 or car 2. good luck.

Interesting, seems alarm has been set-off before<now circuit is ON> and not been re-set back to neutral<re-set circuit to OFF> so when doors are closed, alarm memory retains previous set alarm memory <circuit set to ON>. It'ill go off again whenever door being opened, regardless it have been armed or left open as the memory circuit recognise it still as before alarm set-off<circuit is set ON>.

Solution, 1) Read your car owner's manual in the alarm section, read on how to re-set alarm to neutral if it has been set-off while armed [my experience is by turning the ignition key as if you are going to start the car engine but do not start engine then back to off position, do it 3 times as it will beep after 3rd run]. 2) On 4th run, start the engine, lock all doors then unlock it, 3) Turn off engine, get out from car, lock doors and arm alarm. 4) Dis-arm alarm, open doors and see if it still set-off alarm as before.

If all that doesnot work, go to your local dealer as alarm system has a system fault that can't be fixed without proper equipments.

Follow the instruction on how to accept and mark advise as giving you a core solution. Return a thumb up and praise response. Thank you.

It might not hurt to try the "Microsoft Solution" and reboot the system. First disconnect the AC power then disconnect the battery. Wait 1 minute then reconnect the battery and reconnect the AC power.See ifyou can arm and disarm the system. Then reconnect the siren and try again to arm and disarm the panel. If the keypads beep it can usually give you an error code that will help you pinpoint the problem.

Hit f and then unlock

You may have lock out the remotes. If that doesn't work DEI has a one yr gurantee on remotes. In your box there should be a registration card. Call them.

You Can Turn off the panel beep under the cover that is what i did.