Removing back of irish collection ladies watch for new battery

Doesn't appear to exist 'PG' would be correct but not 'PPG', and model numbers end in an 'X', not an 'S'. If you bought it online, it is likely a counterfeit made in China.

https://pulsarwatches.com.au/collections/watch-finder/

http://www.newdwf.com/viewtopic.php?f=79&t=8617

They are a nice watch, but not 'high end' and values reflect that.

https://www.google.com/search?q=pulsar+ladies+watch+value

Pulsar Europe

https://www.pulsarwatches-europe.com/

..

It is a common logic problem. The watch stopped working. You assumed it was the battery; hence your assumption was wrong. Therefore the obvious answer is that the watch broke and that a battery would not help unbreak it.

Flashing means low battery. Time to replace it.

Yes. The minute hand ticking every 10 seconds is normal. Losing time is either battery or a movement malfunction. Only a trained watchmaker (or presumably Omega) can determine which. Take it back to Omega

After removing all screws you have to use fine pointed tweezers and pry up watch case back using them. Insert between case and case back and pry up using lever action.

Hi helen_markow

You can check for a new strap.

to change the batt on an ebel womans watch i simple. 1 take out screws from bezel. 2 lift off , make sure to keep rubber gasket in place. 3 pull out stem to the set position. 4 be very carefull not to bend / touch hands. 5 turn case upside down, and you will see the opp side from the winder drop out slitely. with your fingernail pull downwards gently on works, then when you have it out a little on that side, turn it back over. and continue to lifft up gently, 5 as you do so, start to rowtate the works counter clockwise. the stem is made to .bend / swivel and the works will turn upside down and lay back into the case. to protect the face while installing the batt. 6 when done gently lift the same way but rowtate clockwise. but make sure you grab sides of works and not the face. ( the hands are very delicate) 7 take the batt to a jeweler to replace you will never find a batt with the same number ( ebel made sure of that ) they want you to pay 140.00 to 240.00 for them to do it. but a jeweler can match it. now that said, once you take the bezel off, your ebel warenty is void. so 140 -240 or $5.00 your choice i have had meny watches over the years all with rubber gaskets and have replaced batts is some five times and the gasket are still fine. and a batt will last 3 to four years. five in 15 years could cost you $ 1020.00 in the long run. hope that answers your question.