How to fix a loose door on model #LSD2615HEW - Admiral 26 cu. ft. Side-By-Side Refrigerator

No make, no model, no year equals no help.

That is normal

You should be able to. May just be loose or may need to replace latch. Take it apart to find out. Try these web sites for how tos: YouTube.com, appliancepartspros.com, repair clinic.com. Just type in ur make and model.. Good luck

This repair is not as easy as you might expect. The door gasket, inner door panel, and insulation must be removed to get at the screws attaching the door handle.

If it's loose from the door, you need to remove the inner door panel to access the screws that hold the mirror in place on the door itself. To remove the inner door panel may simply involve removing some screws, but some models require a special upholstery tool to loosen the panel fron the clips. Once the panel is loose, tighten the mirror and replace the inner panel. Be cautious with door switch wiring!

Is the freezer working or no cold both sides

I believe what is happening is your freezer is not defrosting properly and your auto damper is opening just enough to keep the temperatures safe on the fresh food side. look into freezer and the rear wall. Is frost building up on the rear wall? If ye then this is a defrost issue and you will need to unplug and manually defrost with a hair dryer. Don't be afraid to remove the rear panel in freezer so you can see just what happens when defrost is not taking place. I think it is possible that you have a model LSD2615HEW but you will need to confirm before asking for parts. Inside the fresh food compartment and behind the control panel the model LSD2615HEW for example only has a Click Here=> 12002495 Adaptive Defrost Control Board I say example only because I had to assume your model number. This board is the most likely reason for this problem. Sometimes you may see burn marks on one side of board but not always. Click Here for location=> LSD2615HEW Controls and part 12 in photo is the ADC or 12002495 Adaptive Defrost Control Board The only other cause will; be a defective defrost heater or defrost thermostat. The defrost heater is=> 67004188 Defrost Heater Assembly testing of the defrost heater is also in a short tutorial on this same page. Then finally it is always a good idea to replace the defrost thermostat while inside replacing the defrost heater if need. Part number for the defrost thermostat is=> 67004757 Defrost Thermostat and can be found here=> LSD2615HEW Freezer Components If you have any questions I will be here to answer them for you, If helpful please rate this solution, Thank You, Sea Breeze

their is always some pressure on the filter and perhaps it may be on the border line of freezing,to relieve the pressure turnoff water supply from the house where it connects to the ref. I would have no way of knowing where it is,it could be behind the refrig.,in the cabinet under the kitchen sink,in the basement or anywhere..but after turning it off push the lever for in door dispenser and it will relieve the pressure.

IF it borders on being froze turn off entire unit for a hour

If the screws aren't obvious, they will be locater under a pop out plug on under a nameplate on the handle.

After reading these posts, I fixed my refrigerator door in less than 5 minutes. The little black plastic cam on the bottom hinge was loose. To fix it, take the hinge cover off of the top with an 8mm socket, and remove the three 8mm screws holding the top hinge on. Remove the door by lifting up off of the bottom hinge and set it aside. On the bottom hinge is a black plastic cam held on by an 8mm screw. The screw on mine was really loose. Tightening it and putting the door back on made it work like new. You probably don't have a bad cam, just a loose one.