While mower is running it will not move when you push the handles forward reverse and just sits there the mower is running and the blades are engaged
These units use Hydraulic pumps for motivation. If the unit stopped all at one time, I suspect a drive belt came off.
For both pumps to fail at the same time would be very odd. Check the v-belt driving the wheel pumps.
SOURCE: Knocking in mower deck or belt clutch when engaging blades, motor bogs / slows down
YOU MAY HAVE A BENT BLADE OR EXESSEIVE BUILD UP UNDER THE DECK
SOURCE: Engine runs good and blades turn fine but the
the freewheel control is in the wrong position. push in all the way for mowing. This control is located on the rear of the mower below the seat.
SOURCE: Mower blades willnot engage
make sure the battery is fully charged, check all electrical connections and clean them with vinegar and rinse well with demineralized water afterward.
SOURCE: moved mower out of shed to sharpen blades, moved
with out knowing the exact make and model my only suggestion is look for a lever on the back --usually on the rear right hand axle which disengages the drive some one may have moved the lever when the blades were getting sharpened.
I hope this helps
Andrew A
SOURCE: Husqvarna zero turn mower backfires and stalls when mower blades on
sound like a carb problem clean the jets out
11,033 views
Usually answered in minutes!
×