How do I reset the lamp timer for the infocus LP925 projector? Are there other problems that could cause my issue?

Projector Lamp Life and Brightness - Projector Reviews

www.projectorreviews.com/articles-guides/lamp-life-and-brightness-2/

Feb 26, 2015 - There are still a number of 2000 hours at full power projector still on the... brighter, like projector Y, but Y just doesn't have the picture quality.".

Resetting Lamp Hours on a Sharp Projector - Spiceworks

https://community.spiceworks.com/.../2235-resetting-lamp-hours-on-a-sh...

Jun 12, 2011 - However, once you change the lamp the projector still won't turn on ...If it still doesn't work then there is some other problem with the projector.

How to Repair InFocus Projector Power Issue (LP290 ...

? 1:56
https://www.youtube.com/watch?v=sPGZSJXpxqI
May 7, 2012 - Uploaded by zibodiz
A common problem with older InFocus LCD Projectors causes them to turn off at ... How to Repair InFocus Projector PowerIssue (LP290/LP280) ... How to Install a Bare Projector Lamp into your Projector - Duration: 4:05. by ..

To reset the lamp timer on an in24 go to settings, then select Service. The option to reset lamp hours should be in this menu.

I hope this helps!


Projector Lamps Projector Bulbs Projector Parts Projector Repair Servcie

Maybe the lamp connection is loose. Try also resetting the lamp timer.

The end of lamp timer has reached it's limit and won't let the new lamp strike. What you need to do is Reset the end of life timer. To do this, with the projector switched off press and hold both the up and down Brightness buttons on the projector. while holding them in turn on the projector. Continue holding the buttons in for 10 to 15 seconds This will reset the end of life timer in the projector.


Cheers

if it's the lamp led that is orange, turn off the projector for a minute and try it again. if the lamp goes out and the orange led comes on again, replace the lamp and reset the lamp timer.

projector getting too hot (check filters), or lamp is dying (replace and reset lamp timer)

Hello,
If you are able to measure/show any continuity whatsoever your bulb is way past bad!!
As these lamps do not have filaments.
If you have replaced the lamp you can easily reset the lamp timer from the projector menu.
This procedure can be found in the user manual as well.


Cheers

Hi LuckyLindy

Next time this happens , just take out the main connection to the Mainboard and plug it back in.

Also remember to reset your lamp timer now that you have replaced the lamp !

The Projector will turn off after so many hours of running the same bulb module. The counter will turn on a replace bulb LED. Installing the new bulb module should reset the counter and turn off the LED.

Check the projector’s lamp to ensure that it is securely connected
in the lamp module. Make sure by removing it and reinserting it.

Check the cables for problems.

When testing, power up in this order. Projector, Computer monitor, Computer.

A minor power surge may cause the lamp to shut off. Turn the
projector off, wait at least 30 seconds, then turn it back on.

I hope these suggestions help

the colorwheel is bad. and what's worse, you can't get parts for the lp340 anymore.