How do I short circuit battery to start it up /seiko world timer

[PDF]The Apple Watch User Guide (PDF)

https://manuals.info.apple.com/.../apple_watch_user_guide.pd...

Apple Inc.If you have difficulty seeing the Apple Watch or iPhone screen to set it up, .... Note: If you disable your passcode, you can't use Apple Pay on Apple Watch. ..... Alarm • Timer • Stopwatch • Battery charge • World Clock • Your monogram (displays ...

[PDF]Cal. 7T62 - Seiko

www.seikowatches.com/support/ib/pdf/SEIKO_7T62.pdf

SeikoYou are now the proud owner of a SEIKO Analogue Quartz Watch Cal. .... into consideration the time required to set the ALARM hands and to adjust the .... The single-time alarm cannot be set for a time more than 12 hours ahead of the current ...

How to Set an Alarm on the Apple Watch - YouTube

I need instruction booklet for Seiko world time card model EK450F YJ30-4001.

Hi...The circuit Board my be defective if an old battery was left in to long ...As for not beeing supported any longer this watch is still beeing sold and is less than 20 years old it should still be supported a solution would be to replace the battery and gently clean the circut board with a dry soft clean tooth brush mainly the areas where the battery is placed

Go to this link for your instructions. The title page is in Kanji, but the instructions are in english...


http://www.cei-ultrak.com/seiko/s149.pdf

Good luck and don't forget to vote.

If you do not have instructions you can get them from their web site "Seiko.com".

Click on "support" and then on " instruction booklets" and then scroll down the page and you will see
a list of watches.
Download the PDF for your watch.

If you go to "www.sportscounters.com/seiko-s149-stopwatch-printer-all-in-one" you will see a telephone number, try calling them for advice.

(This problem is fairly common after replacing batteries, so I suspect that there is a procedure for resetting the timer.)

I have the same problem. need instructions for 8v22-7000 World Timer

If the stop watch hands are not in the "0" (12 o clock) Position, follow the prodedure below to set them to the 12 o Clock position

1, Pull the crown to secound position
2, Press Button "A" for 2 seconds.
3, Press Button "B" to Adjust the minute Hand to "0" Position
4, Press Button "A" for 2 secounds then press Button "B" to adjust secound hand to "0" Position
5, Press crown into normal position

From:

AmFix Jewelry & Watch Repair
203 N. LaSalle Street,
Chicago, IL 60601
Ph: 312 641 7000
Email: [email protected]
Web: www.goamfix.com

Turn knob to set on "Match" Pull out crown knob. Press both buttons for 3 seconds. When you release both buttons it will beep and both hands start moving. Press either button to stop movement. Then press the top button to set the minute hand to 12 oclock. Press the bottom button to set hours to 12. Press in crown and turn to "Time" Pull out crown and set time the same way.

you often need to do a full reset on 7T32s (& other seikos) after a battery change. there is a small reset contact in the rear of the movement which needs to be shorted to the top of the battery (the movement is engraved with wording to this effect, something like "AC reset", I can't remember exactly). you might also try pulling out the crown all the way (2 clicks) then holding both upper pushers in for a few seconds. it's unlikely to be a buggered motor unless it's one of the subdials that's failed.
hth-
duncan.