Everstar m# mpm- 08cr-bb4

Either clogged or not level. Vacuum tube, possibly clean the pan, make sure it's level.

If you need further help, reach me via phone at https://www.6ya.com/expert/thomas_092728000e6acb79

This means that the internal bucket is full and needs to be emptied.

check sensor

The P1 code means the lower water bowl is full.
Put a pan under it an pull the lower plug (some 10" below the upper drain plug that I hope you have a hose attached to.

No. It pulls water out of the air (dehumidifier) and will fill the bucket pretty quickly on a hot humid day.

"The black plate with floater in the bucket" is what signals that the bucket is full of water. So if it isn't in the right place then you will get "P1" (Problem 1 which means bucket is full). The "black plate" needs to flop down inside the bucket for it to register as empty. When the bucket fills the floater makes the plate go to the top and it shuts off the unit.

Set it so it doesn't have to work as hard (i.e. higher temp) and it will generate less water.

http://homeappliance.manualsonline.com/mdownloads/de993dd8-6ee1-4d80-9bf0-30a20d6a0e2d.pdf

PDF File