Can I get a list of error code and what they mean and how to fix. I keep getting nF as an error. What does this mean?

www.fixya.com > ... > Neptune > Maytag Neptune MAH5500B Front Load Washer

Apr 14, 2009 - CODE IN MAYTAG WASHING MACHINE Hello & Welcome to FixYa NF error in yourMaytag is displayed due to no fill condition, when the washer tries to fill but ... SOLVED: Maytag Neptune MAH6500AWW '03 front ...
10 answers
Nov 9, 2016
SOLVED: HOW TO FIX NF CODE IN MAYTAG ...
2 answers
Oct 2, 2011
SOLVED: Machine is flashing nF code
10 answers
Jul 13, 2011
Maytag Neptune MAH9700 Front Load Washer Nf code ...
10 answers
Jun 21, 2011
More results from www.fixya.com

NF means no fill.

Samsung Washer Error Code NF (Fixed ...

www.appliancerepairlesson.com/.../samsung-washer-error-code-nf-fixed/

Jan 11, 2014 - What does the error code NF mean on a Samsung washer? ... You can set the washer to any cycle and test each solenoid for proper voltage. ... Next would be to check the screens on the back where the water hoses connect. ..... Hi, you don'thave any power to the water valve wires when it should be filling?

Dits a no fill error so you probably need to replace the water inlet valve. The link below goes into it in more detail. Samsung Washer Error Code NF Fixed

try jimmies.com

please see the cause and proceed to test the water inlet valve can be defective and replace it.use the common sense,see the diagram
God bless you
Water Supply Error occurs when water level frequency does not show changes more than 100Hz or water is not supplied up to the preset water level after 10 Minutes or more at the time of initial water supply. The error status can be cleared by turning the POWER switch OFF and back ON.

Hello & Welcome to FixYa

NF error in your Maytag is displayed due to no fill condition, when the washer tries to fill but is unable to nf is displayed. Please check the water inlet valve for any clogs and obstructions, you can also clean the inlet to solve the issue. Please get back to me if you have any other questions.

Kevin

Hi


Thanks for using FixYa. Error NF means No Fill. The washer has tried to fill but was unsuccessful. NF indicates No Flow. There is something that is interrupting the inbound flow of water to the washer, either hot or cold. Sometimes this happens when water service in the area is interrupted, creating an air pocket that causing the water valve not to sense water.

Try running the diagnostic test by—

• Press the delicates and heavy soil keys together for 3 seconds.
• You are in the service mode.
• Now, press wrinkle free key, cold water should start entering.
• Then, press the cotton sturdy and hot water should flow.
• To exit the test mode, either unplug the machine or press the delicate and heavy soil again for 3 seconds.

Please do rate the solution if the issue is resolved or post a comment for further assistance.


Thanks
Rylee

NF means "No Fill".
I was getting that code too, but we only had the cold water hooked up. I hooked up the hot water and I have not received the error since. I still only wash with cold, which is strange.

water fill valve screens may be plugged filling too slow or valve may be bad or is one of the hoses turned off