Can I use the Zanussi jetstream 1400 front panel in a country where electricity has 60 cycle

check door inter lock also pressour switch

check heat sensors or element

no agitation check timer and control board. but more likely culprit is the water pressure switch. Which determines water level and when machine goes into agitation mode?

clean filter and reset washer

Hi,

Blue wiring loom that goes to the front control board from the maim control PCB has bad connection on the user interface.Clean PCB terminals and crimp connector to make connections tighter.if this doesn't work could be user interface fault or main PCB fault.

Hope i helped you.

Thanks for using ' Fixya ' and have a nice day!!

bad smell coming from inside the drum how do i fix it? thanks

Hi

E10 means there is no water getting in to machine.
check water supply if ok then fault will be fill valve.

regards

it could be the concrete ring situated at the front of the machine. i had the same problem with mine 2 years ago.

i have a problem with my zanussi aquacycle 1400 xtra capacity. some times it works ans some times not like there is a problem with the power the alternater? should i change this part? please help as my wife is driving me crazy.

assuming you had correct value fuse, fuse blowing may have been caused by a machine fault.after power outage, cycle should resume.