Model av220c2, keeps freezing and throwing error code 2023 and wont feed paper through
Step to Fix Brother Scanner Error Code 2023:
-To handle this blunder, first, you have to kill your Brother printer and sit tight for like 15 seconds.
-Turn on the Brother Printer again and attempt to filter once more. -On the off chance that you are as yet unfit to check, evacuate all the power attachments and USB links from the printer and the PC.
-Check the USB ports completely. Supplant them in the event that they have to supplant.
-On the off chance that the USB ports are not harmed, reconnect them and attempt to filter once more.
-In the event that the Brother Scanner Error Code 2023 still repeats, uninstall the scanner driver and DSmobilecapture programming.
-From that point onward, you have to download and reinstall both the driver and the product.
-At last, attempt to examine once more. Ideally, your concern will be settled.
If facing any problem related to a printer please visit us Brother Scanner Error Code 2023
SOURCE: Paper Feed Problem
I had this same problem - you could hear the printer "trying" to pick the paper up. After a few cycles it would stop and pop up the media jam error. I noticed this would never happen when the try was half to completely full - only when the stack was low. I pulled put the paper, inserted a feather duster, applied some elbow grease (or wrist in this case) - problem solved.
SOURCE: PAPER WONT FEED IT KEEPS
I have a HP Photosmart A626. The paper won't feed. It seems like something is blocking it and sometimes takes me 5 minutes to get it in where at that point the paper is ruined.
Chris
SOURCE: hp p1006 wont load/feed paper
i know this is not perfect but...
paper runs out during printing... so
1)open the front cover
2)close the front cover
3)IT WORKs
If i helped you please rate me
SOURCE: Error code C380 paper feed failure
c380 indicates auto-toner error for black developer (K).
Check following:
Is the harness between the LGC board and the developer unit drawer connector open-circuited?
Is any harness inside the developer unit or the auto-toner sensor harness open-circuited?
Is the auto-toner sensor connector or the connector CN341 on the LGC board disconnected?
IF connector no problems, then u probably need to replace the auto toner sensor.
SOURCE: Error code 004-332 restart printer. Paper not
Check to see if your toner cаrtridges аre in the right position and locked in place. Then, stаrt the printer аgаin.
1,339 views
Usually answered in minutes!
×