Monolta izhub 362 hwo to reset drum counter

requires a tech to first clear counter remove the image install new drum cleaning blade and developer and run required porocedures

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/normanj_7893313f0751935f

go to service mode and in counters option clear the counter of fusing unit.it will reset.

Restart the machine.If code removes then its OK, otherwise press the utility/counter button and restart the machine.Don not leave the button.Keep the button pressed.Trouble reset will appear on screen hit it and restart the machine.

Thecopier has a counter the drum unit. "PC" means photo conductor, I don't remember if the copier will lock up if the drum unit is not replaced? There is a counter that needs to be reset once the drum & new developer is installed.

Insert the printer driver CD for bizhub 362 into CD ROM drive and run the setup utility.Read and follow the instructions on the screen.your pc will automatically detect the machine and install the drivers,Just use the printer driver cd if you do not have then download the driver from internet and install them.its quite simple.

You are going to need to call your service company and have them replace the drum unit for you. Don't listen to anyone that gives you the service mode entry procedure and drum count reset. This WILL screw up the AIDC (Automatic Image Density Control) and the machine will shut down with a COF32 code. There is a very specific procedure which must be followed when replacing/resetting the drum counter on these machines as there are several "counts" that are tied together. Trust me on this as a 27 year Minolta Tech, spend the money and have the drum unit replaced. They are good for 100,000 copies so even tho it may cost some money to do. Divide that cost by 100,000 pages and it gets pretty cheap.
Good Luck and Thank You for using Fixya.

Press utility/counter button.on panelPress user settings.on touch screenNow check all the tabs.in one tab you will see the volume option for beep sound.decrease the volume and press ok and then press reset button.its done.

Drum counter is reset by installation of a "NEW" drum.
There is a small fuse at the rear of the drum on the top( you will see the 2 brass contacts) When a new drum is installed, the fuse blows and resets the drum counter. Installing a used drum will not reset the counter as the fuse is already blown.

Reset the drum counter as follows:

1. Open the front cover.
   
   
2. Locate the control panel button under the LED lights on the left side.
   
   
3. Press the control panel button until all lights are lit, then release it.
   The Drum counter is now reset.
   
4. close front cover

if the Drum LED is still lit after replacing the drum unit, the Drum counter may not be reset.
Reset the Drum counter as follows:

1. Open the front cover.
2. Locate the control panel button under the LED lights on the left side.
3. Press the control panel button until all lights are lit, then release it.
   The Drum counter is now reset.