Bosch WFO2060 not spinning at spin cycle.

Hi Justene,
i Think its control circuit has a problem.
or the fuse for motor drive circuit is damaged.

please check with electrician.
regards.
nuwan

I am not sure if Bosch has a "load sensing" sensor, but I would start there else you may have a motor issue, or bad capacitor on your motor.

A LD (Long Drain) error code means that (more or less), the drain pump is failing.

Either a blocked filter or worn carbon brushes

Hi mwilczewsk,

I believe your drain pump filter is just clogged. The drain pump is trying to pump the water out before the Spin cycle, but can't. Usually this is caused by a foreign object that is obstructing the impeller. See my tip on how to access, drain & clean the Drain Pump Filter:

ACCESS, DRAIN & CLEAN THE DRAIN PUMP FILTER

After this, the Spin cycle will run, after the drainage procedure. If it does not, then you may need to replace the Drain Motor. Which is a easy task.

Kind Regards :-)

* If this solution helped you, please rate it

Sounds like you cannot activate youre imagination maybe Ill do this for you one time here goes ~: You or someone left coins in your pockets jeans cardigan whatever they got out of garment while in the wash spin and worked themselves into the machine and now its bug-gerred innit?

Hello, Thank You for using FixYa. I will be helping you today.Check the lid switch. Since you didnt give a model number it makes it hard to figure out but sounds like the lid switch
Thank You and please rate my answer if it was helpful..

probably not draining fast enough, check for blockages at filter, sump, outlet and plumbing

Make sure that all the water has drained from the washer, if it has a filter, remove and clean, it is located behind a removable plastic panel at the front of the m/c, if it still does not spin, suggest you remove motor and check the brushes for wear, this is often the reason it won't spin, but will wash o/k.
Plz rate my solution.
Thanks

make sure you remove all the shipping bolts per installation instructions then rock washer with hand and screw legs down till it doesn't rock then load an go call me back if any problems