Why does the code F35 keep showing on the machine

It helps to have FULL make and model in such questions, but here are a few ideas

The F35 error code indicates an analog pressure sensor error. The analog pressure sensor is the component that detects water level in the washer tub. This error can usually be cleared but it will occur again if the main control board still detects a problem with the signal from the analog pressure sensor.
Jun 4, 2011

F35 error code appears during cycle - iFixit

https://www.ifixit.com > Answers > View > F35+error+co...
About

Whirlpool duet washer f35 error code

https://all-errors.com > whirlpool-duet-washer-f35-error
The F35 error code in the Whirlpool washer indicates some problems with the water level pressure switch. This sensor is responsible for measuring the amount ...

Troubleshooting the F35 Sud Error Code in the Whirlpool Duet ...

https://www.youtube.com > watch
PREVIEW
12:49 Troubleshooting the F35 Sud Error Code in the Whirlpool Duet Steam Washer · For more tech advice on ...
YouTube · SamuraiRepairman · Oct 5, 2013

Look up you tube f35 code some info there on it

Cut down on your soap i only use very little soap and it works great.No more SUD code

Analog sensor failure. Replace that puppy using this VIDEO GUIDE

If you need further help, reach me via phone at https://www.6ya.com/expert/dan_73bbd84fe1d95b61

Hope this helps.. The "F35" error code is indicating a problem with the analog pressure sensorswitch operation (key#20). There could be a blockage in the air dome or pressure switch hose. The pressure switch is located underneath the main top on the right hand side. The air dome is located on the back of the tub on theleft hand side. If the pressure switch hose and the air dome is clear of any blockages the likely failure is the water level pressure switch (key#20) part# W10156252. Replacing the pressure switch will likely resolve the "F35" issue.

Hello

F35 error means that there is some sort of issue with the steamer electronic board and analog pressure sensor has gone bad. Check that the hose is firmly attached with the washer and is not blocked. You can also check the water level pressure switch operation. Please get back to me if you have any other questions.

Kevin

hello
what The F35 error code indicates that the water temperature sensor reading is out of range (below 23 degrees F or above 217 degrees F)
The f35 error shows you and indication that ice maker sensor readings are out of normal range.
then what you need to do to fix up the problem is to bale out the water from it then clean up all form of water ant dry you can see from the screen

Please before you can carry out this instruction you will have to put OFF all source of power supply .

thank you and good luck.

F34, F35 and F36 are fusing errors.

To unlock:

- Turn off machine
- Turn it on while pressing keys 2 and 5 simultaneously
- On the menu that shows up, press 1st option "Software SW"
- Using the up and down keys, navigate to switch 3-1
- Press OFF
- Cycle machine power

Don't mess with anything else or you'll risk more trouble than you're having right now.

If the error comes up again, you have something wrong with your fusing unit. Check it.

F35,= SUDS

set a few washes without using any soap to flush the pump out.

Use less detergent and use a liquid rather than powder.

IT IS THE ANALOG PRESSURE SENSOR NOT THE STEAM CHAMBER.