When i turn on the laminator it goes though a cycle like a bit test then bleeps and the logo flashes (constantley) and will not turn on i have been unable to stop the bleeping and it will not heat up?
LEONARD MCCARTHY Your answer does not help!!!!! I have a jupiter 125 that wont stop beeping i Open it removed all the screws to uncover the motor drive and there is a sensor that pop up and down this is what releases the top cover when it making a loud noise ! it was stuck by the spring metal a the sheet of metal! there also a ***** on the bottom of laminator that say "remove this *****" this hold the spring sensor and stop if you tighten this *****. it stop the noise when i connected to trouble shoot but when i put back together i started making the noise again! my guess is that has to do with that sensor spring is getting stuck or faulty!
Unfortunately, this message was posted in the section for paper shredders. If you still need an answer you will need to repost it.
3,167 views
Usually answered in minutes!
×