First read articles on "ESD".
Link:
http://www.computerhope.com/esd.htm
Look for any warnings or post messages during boot sequence
1. Verify the RAM are the correct modules for your computer.
2. If the RAM is correct then remove 1 stick of RAM
3. Check the jumper settings on the HDD to verify Master, Slave, or Cable Select.
4. Remove the hard drive and verify the system will post.
5. Reinstall the HDD and boot to Bios and verify all devces are detected.
6. You might reset the Bios with the J2,3 to the J1,2 jumper.on the mother board.
Troublshooting is a process of elimination. Start barebones and work your way up!
Hello
Safety shoes should have a stamp on the sole "ESD protection". Basically, footwaer with a sole made of polyurethane is ESD protected. The protection level depends on working conditions.
×