Why is my kenmore 28262 frezer not cold - Kenmore 53642 / 53644 Side by Side Refrigerator

It could be stuck in defrost. Check your defrost heater, and see, if it is still hot. If it is, then the defrost timer is stuck. When it goes into defrost, everything, stops working, but the defrost heater and light. As long, as the defrost timer is on, nothing else will work, as far as the compressor, freezer fan, and any cooling/freezing.

Hi,

Check out these tips...they can help you figure out what is going wrong withyour refrigerator and why it is not cooling

Refrigeratornot Cooling or Fridge not Cooling

How to Defrost Refrigerator DefrostTimer Problem

WaterRunning in refrigerator from Freezer

Refrigeratoror Freezer not Cooling or Getting Cold
heatman101

If understand your problem as being a bad fan in the freezer. Take the plastic or metal panel off that covers the back of the freezer. Inside you will see a fan that is held on by two or 3 screws 10mm or 5/16. Unplug the wires to the fan and remove the screws. This is an easy fix just make sure you unplug your fridge first. Hope this helps you.

IF THE FREEZER IS SEMI COLD CHECK THE FREZER FAN IF ITS FROSTED UP IT MAY BE A DEFROST PROBLEM, ALSO CHECK THE CONDENSOR IS IT DIRTY

If you need further help, I’m available over the phone at https://www.6ya.com/expert/dude_653d05454b389bba

Is the indor fan working or not.To look for indor fan is working or not go to frizer side and look for cold air to came out, if not i think you must have defrost thermostat broke to

weak evaporator fan!!! :)

looks like you have a leak in the cooling system, call sears out right away to save yourself from an even more expensive repair.

is there water in your icemaker.if so then its up to icemaker to do its part.frezer temps must be near 0 degrees.if no water in icemaker is the line in the back of the frezer frozen [top back where water passes thru frezer wall into frezer section.if its not frozen,am i then getting voltage to the water valve when the ice maker cycles.if not then icemaker is bad.if your ice bucket is on the door[whirlpool,kenmore]there are boards in the frezer section that can fail.i know that dosen't tell you what the problem is .but it does give you somthing to go on with.God bless ,tom

check the freezer compartment at the back wall. see if there is frost build up at the back.
sounds like a fosted evaporator to me.

check also the evaporator fan in the freezer section if it is running.

if not, then there is your problem.

tnx 4 using fixya,

drcool

I was out of town and the top part, the refrigerator part lost the coldness. The freezer which is on the bottom is working ;just fine.