Why do my machine flashes red lights when pluged in AC and nothing else works ?

Unknown what model it is - you can use the comment menu to give more information about your problem.

Possibly a child lock was set according to the Bosch WAE Range Washing Machine link below:

https://www.ukwhitegoods.co.uk/help/fault-codes/laundry-fault-codes/3308-bosch-wae-range-washing-machine-fault-codes

if the door light is not going out it is an indication that the door switch is not working. this would also cause it to not run because it thinks the door is still open.

have you checked the fuse box in your house?

Bosch 1200 classixx express washing machine. Upon switching on my machine, a little while later all of the lights on the control panel were flashing except the Start button. I tried to push the buttons but there was not the usual sound made upon depression of any of the buttons. They continued to flash. I switched the power off and cleaned out the pipes at the front of the machine to eliminate any obvious problems. Please help

Hi,
Here is a tip that I wrote that will help you with your dishwasher not draining problem...

Dishwasher Problems - Water will not drain out
http://www.fixya.com/support/r4078724-dishwasher_problems_water_will_not_drain

heatman101

Could still be the water inlet valve. What you need to do is pull the washer out where you can get to the valve and the plug. Unplug the inlet valve and start the washer and when you start it as normal check the volts of the plug and see if its 110 if it is you know that the valve is getting power to open but not,replace the valve. If you dont get any voltage then it could be the relay or control board

it sounds like the brushes have gone in the motor that turns the drum

check the pump clean out. sounds like something is jammed in the pump

all lights are flashing on bosch classixx express no thinh working no water intake door is locked what is the problem and can i do it myself

Washing machine stops at the spin cycle - light flashes. Have to drain water out manually. Happened last week and was then able to run an empty rinse cycle. Machine worked normally for another week. Same problem today but have had to drain water manually from the drum after trying an empty 90 wash and rinse cycle (both stopped on the Spin and flashed). Any ideas? Thanks. x