Moved to new home hooked everything up washer will not fill

hi Anita.
see if this link helps you out.
Washing Machines Hot water function won work Google Search

When I start a new cycle, I first hear the pump run to empty out all remaining water, and after that I hear the motor run for the regular washing cycle, but there is no water in the dishwasher. After a few minutes, the cycle stops, and the washer claims the dishes are 'clean'. When I try starting a new cycle over and over again, about one in 20 times, the cycle will run normally with water. But then the next time, the problem starts all over again. Once a cycle starts correctly, everything works fine, including the rinsing.

Your washer has a set amount of time to fill. If the flow is low and the time runs out, then all you will get is the amount of water that was able to fill. Check your lines to be sure that they all fully opened.

Sounds like jammed open solonoid valve on hot or cold......water?,,quite simple to fix parts about *£8.00

Our reset for the jets were hidden in the master closet behind the tub. We also found another access point to the tubs inner workings in the same place. Also, make sure they open all the air intakes and the tub is filled prior to testing. On ours if water is not above a certain level it won't come on.

2 things make sure the washer is balanced. and make sure theres nothing was stuff in the bottom of the washer when you were moving

when you turn on the sprayer you should hear a pump motor running, try this with the engine off and key on so u can hear better. if u dont hear the pump then check the fuse if its ok then u will need a new windshield washer pump. if the pump is running when u activate it check for a leak in the lines. if you hold the washer button down long enough and the pump is running then you will see washerfluid leaking from somewhare. have hood raised when doing this so you can see better.

• check the wires that connect to the motor, they may have worked loose during the move.
  
• also check the lid switch and make sure it is clicking when you open and close the lid.
  

check the sreens in the hot and cold water valves on the machine make sure there not plugged with rust

the carbon brushs in the motor need replacing,on the w6021 the fault you get is a clicking sound when you press the start button.