How to reset 62dc1d? - RCA D52W20 52" Rear Projection HDTV-Ready Television

Contact Arris arrisi.com

it could indicate that the TV is in standby mode, waiting to be turned on. In this case, you should be able to turn on the TV by pressing the power button on the remote or on the TV itself.
If the red light stays on even after attempting to turn on the TV, it could indicate a problem with the TV's power supply or circuitry. In this case, it's best to consult the TV's manual or contact LG customer support for assistance.
Regarding the RCA D52W20 52" Rear Projection HDTV-Ready Television, if you're experiencing issues with this TV, it's best to provide more information about the specific problem you're encountering, such as error messages, distorted picture or sound, or issues with turning on or off. This information will help diagnose the problem and provide more targeted solutions.

Hi,
Your LG HDTV is in protect mode that why you can see light .To protect further damage of some component parts.There is something internal problem inside maybe there is a shorted or leak capacitor in power supply section.

Regards:
votit

Make sure your TV is turned off at the power switch for at least half an hour. Undo the two screws on the lamp cover which is on the right hand side of the TV as you look at the screen.
Remove retaining screws on lamp case.Lift up fixed wire handle on lamp. Pull out knob slowly and remove lamp case. Insert new lamp gently. Tighten screws. Replace cover.Reset lamp time on menue.

ure bulb will be on the way out go into the menu and there should be a lamp counter if its close to 8000 hours then its due for one, check ebay for cheapest price as they arnt under warranty

My LG lcd tv did something similar, kept making a clicking noise every minute or so. In the end i took the back off and checked could see there was one popped capacitor on the power board. Replaced for £3 and has worked fine ever since. Hope this helps

The P300 has 3 kinds of reset mechanisms, 1. Soft Reset: you can keep all DRAM data. Procedure: Push the Reset button 2. Hard Reset/Save SDRAM -- Use hard reset/save SDRAM mode to reset the MobilePro P300 without losing the data in SDRAM. Use this mode if the safe software reset mode doesn't improve system operation. Procedure: Reset Button and Power Buttons at the same time. 3. Hard Reset/ Clear SDRAM: You will lose all data. Use to reset the MobilePro P300 and delete the contents of SDRAM. Use this mode to reset the MobilePro P300 to its factory defaults. This is also referred to as a hard reset/clear SDRAM. **Caution** This procedure will delete all user installed applications and user data. If necessary, back up your data before performing the hard reset. Procedure: Push the Reset, Power, and Record Buttons at the same time