P100 was working took 1 picture and froze open. white screen won't charge

hi,
did you check the picture through the view finder ? if it is clear, then there may be snag in the monitor, normally the connecting cable to the motherboard become break, if so should replace it.
if the picture is visible when you turn the monitor to either side, then you can confirm the fault of the cable.

The LCD can be replaced. The part is around $50-$75 I believe. It can be tricky to replace, but if you take your time, you can save money by doing it yourself. The screen sounds cracked or broken, and black & white will not work either.

good luck

I installed it today on my system - Windows 7 Pro 64-bit operating system. It installed and took a while, but I didn't select the CAD drawing part to install; I just selected the Hijaak part to install to get screen clips. That part installed, and works, but differently than on XP. You can't change the option for the key to get the clip, so it is Ctrl/Shift/C. Then a white screen comes up (wish it didn't). If you know about where it was you wanted to clip from the picture you were seeing, you can select it using your choice that was set up before the clip - rectangle, window, screen, free selection, star, etc.. On the white screen make your "blind" selection and then it clips from the picture you were viewing. Then you can paste this into a MS Word or Photoshop. If that white screen didn't come up covering your picture, it would work fine -- don't know how you could get rid of that. In Photoshop the layers show the background as total white and then your clip as the 2nd layer and it has the white outside the selected area, which can be inverted to delete that white background. If anyone knows a work-around to not have that white screen cover up what you want to see - that would be great!

Also in the Windows Pro 7 64-bit you can choose to install Windows XP SP3 from the MS site and work with your old programs that way. I haven't tried this.

You can re-charge your battery fully by the provide electrical charger for 6 hr , then you can try and send me status.

Make sure the player is fully charged. 1. Connect the player to your computer. 2. Make sure the computer detects the player.
NOTE: If needed, switch the player to MSC mode, 1. Turn device OFF. 2. Slide the Hold switch down to Lock (orange color showing). 3. Press and hold the center button while connecting the device to the PC.then connect it to the PC. Next Be sure the battery is charged 1. Leave the player connected for approximately 2 hours to charge. 2. Disconnect the player from the PC. 3. Verify if you can turn on the player. 4. Reset the player if necessary. To reset the player: 1. Press and hold the Power/Menu button for approximately 20 seconds. 2. Release the Power/Menu button. 3. Press the Power/Menu button again to turn on the player.
If that does not do it, re-seat the battery: Then try and see if it will come on with out the battery hooked to your computer, which I see you have done but did you change modes MSC to MTP . next delete the song it keeps hanging on and re-copy it back on to the player from a different folder or re-rip it from the CD and copy it into a new folder then re-copy to the player.

Press and hold for 20 seconds the ON and PLAY (>||) buttons at the same time.

I had a similiar problem and i took the battery out and my sim card and left them out for a few hours then i tried putting them back and mine seemed fine, did you try charging it? I would give verizon or watever service you have a call and if they dont pick up bring it down, they may be able to help. I would replace it.

On the jvc digtal video camera GR-D30 there is a recall problem is lens cap message
on but the cap is off but the lens is still grey shipping the camera back no charge
the jvc support information number. i call

did you charge the phone???

Hitting the Cyber Shot logo on the front really works - ye legends!!!