Need spare part for hb 790

Its speed regulator electronic circuit inside is faulty. There is a control circuit to determine the time and speed of the blender. It will contain a pre-programmed IC. This board is nor a repairable one. It should be replaced as card basis. Its one touch pulse only energises. No other speed regulation section does not works, and the IC related to this is faulty. Normaly pre-programmed; otherwise known as {PIC} ICs are programmed by the manufacturing company, and will be difficult to get from outside electronic spare-part market. So you have to contact the Breville service center to get this device repaired.

Try typing in your model number at the HB's parts site, located by clicking here .

Possibly on the cheap at http://www.ebay.com/itm/VINTAGE-HAMILTON-BEACH-BLENDER-REPLACEMENT-GLASS-JAR-LID-with-FILLER-CAP-BLACK-/161614461759?pt=LH_DefaultDomain_0&hash=item25a0f8fb3f Try typing in your model number at HB's parts wesite located by clicking here . Check out the many www sites like abtecparts.com and goodmans.net. Besides matching description, I would match the pictures of what you are going for against what you've got as much as possible. Good luck!

im selling a Ronson corp. Blender model hb-2 it works great :D $40 dlls it haves manual.
im in san diego ca.

safemanuals.com is a useless site

make sure blade is pressed tightly onto shaft... should click into indent. if not then you need a new blade piece.- stripped

The full manual can be downloaded on safemanuals.com in PDF format.

http://www.appliancepartspros.com/partsearch/model.aspx?model_id=239820

go to hamilton beach .com with model and serial no down load a book