Here's a link to an online manual regarding the SJSS25 Microwave oven: http://c394327.r27.cf3.rackcdn.com/WriteUps/0439-Kenwood_KENSJSS25.pdf
SOURCE: How do i replace the
If
there's no obvious removable cover over the bulb (and the owner's
manual doesn't address it) some disassembly may be required.
Always unplug a microwave before removing or installing any bulbs.
If
it's an over the range type, remove the vent grille across the top and
see if bulbs can be accessed there. There may be a panel on the bottom
covering the light(s), instead.
If not, chances are
you'll have to remove it from the wall, then remove the outer cover. If
so, the installation instructions are very handy, and it's best to have two people since the microwave can be heavy and awkward.
If you don't have your instructions, please reply back with your brand and model number.
Once it's out of the wall, the outer cover (wrapper) will need to be removed, just as you'll need to do on a counter top model.
On a counter top model, be sure it's unplugged, but otherwise ignore the instructions above this paragraph.
The
screws you need to remove should be pretty obvious, but a special
driver (such as a T20H Torx type or GTXH20-100) may be needed.
Be sure to put all the screws back in the right holes, since some may be special grounding screws.
Bulbs can be had in most grocery stores, hardware stores, home improvement centers, and big box or department stores.
Many models use halogen lamps. You must not touch the new one with your bare skin, as the oils will shorten the bulb life.
We're happy to help you with free advice and we'd appreciate your thoughtful rating of our answer.
SOURCE: I have recently bought a
The turntable system consists of the motor, the coupler, the turntable support with rollers, and the tray.
You can see and hear a video of how a turntable motor should sound when you rotate it by hand.
If
yours is not set to be off via the control panel, and it won't rotate
or it sounds like it's grinding, etc., you may have a bad motor or
plastic coupler.
To
replace either, you need to unplug power, then remove the bottom cover
of the oven.
For parts and service, you should contact Kenwood at the number in the owner's manual.
We're happy to help you with free advice and we'd appreciate your thoughtful rating of our answer.
SOURCE: Microwave will heat v.slightly but will not cook
Make sure that the power level is on high. I'm guessing you already checked that. There is a malfunction in the microprocessor, the firmware in the EPROM, The Litz Coil (high voltage high frequency) or a bad Magnetron tube. Either way, unless it is a super high end MW, it is not worth repairing unless you can do it your self. If you have a volt meter I can go through some basic troubleshooting with you when you repost. This is high voltage stuff so be careful, eye protection, rubber gloves, no jewelry.
SOURCE: Kenwood microwave SJSS25 not working
In all likelihood the mangnetron has failed, or perhaps even the Power Supply. or a fault that is shutting the system down for safety reasons You need to have it serviced by a reputable service centre/man.
Ensure you get a firm "Quote" before proceeding, and remember these days the cost of repair can equal or exceed the price of a new one.
Most major manufacturers supply manuals
online so if you were to log on to the manufacturer's web site, you
may be pleasantly surprised as usually, if available, one is able to
download, by model number, Customer
Instruction Manuals, Dealer
Network for spare part supplies as
required.
The information is normally free of
charge.
I hope this helps.
77 views
Usually answered in minutes!
×