Will not fill at start - Crosley CW6000 Front Load Washer

i would go heavy on the deoxit D5
https://www.google.co.uk/search?q=deoxit+D5&ie=utf-8&oe=utf-8&gws_rd=cr&ei=IhJAVZevEILsat3agcAD

i think your timer control switch
has carbonized contacts...

so perhaps the contactors are blasted a bit

either this or look for a new program control

Pressure switch stuck you can pop the hose off the switch and blow thru hose it may reset and fill correctly before agitation will eventually stick again.

you may have a fill time out issue here
check you hoses
disconnect them and clean the screens

if the unit fill the first time you start it after it fill and starts to wash hit cancel let it drain if it fails to fill again 2nd or 3rd time you have a bad fill valve

water level should be approx 1/4--1/2 inch below the heating coil.. this is normal fill level

I am almost certain that your problem is the fill solenoid.

If it does not work, there will be no water entering your machine.

I would either remove it and test it or just replace it at this point.

Tim

To javed_iqb904, does the drum actually fill or does it seem like that water is draining out as it's filling?


To neonllama19, if it fills with the tap on and the machine off, it sounds like a defective water valve. If it never stopped filling it sounds like a defective pressure switch or hose to the pressure switch is loose or diconnected.

You may have a faulty door switch.

The inner tub on some machines does rotate very slowly while filling to assist with the even distibution of the load. If the agitator is turning back & forth while in fill mode, you could have a timer or transmission problem. You need a tech.