1600n power up

Hello Marc Miller,

BAFFLED:
I am a bit confused by your remark
"at night after 8pm" but I think I understand.
I have personal experience that FULL-MOON affects
PEOPLE... but the CARS/TRUCKS... Not so much.

My guess is a READ-OUT of your DIAGNOSTIC
TROUBLE CODES (DTC) would (in the hands of
an accomplished mechanic is going to point out
your issue(s).

Some muffler shops and parts houses provide
these services for FREE...
(just know your options/prices before you go
(see below)).

Other than I personally believe you are
headed HOME (family, hearth & heart) you
probably suffer the torment all day long...
but it really stings when you want to be home...
I doubt any OTHER relevance to "8pm"...
ESPECIALLY since about 70% of this planets'
people just set our clocks forward AN HOUR
only a few weeks ago...

Another thing that has baffles... is your muffler.
Although the exterior MAY look intact...
195,000 miles is not a bad ... I have experienced
your trouble...

When a car runs "sometimes" that eliminates a
TON of considerations... (things that are OK).

Once the code are read... the FIRST MISTAKE
EVERYBODY makes is to change out perfectly
good OXYGEN SENSORS...

They are only upset because your
catalytic converter AND/OR muffler
are LIKELY keeping your EXHAUST from
getting out...

Just a thought...

ROCKAUTO
1997 JEEP CHEROKEE 4 0L L6 Catalytic Converter RockAuto

Carnac the Magnificent

Dell has an article devoted to just this for you model printer, I'm posting the link below. I hope I could help.

http://support.dell.com/support/topics/global.aspx/support/kcs/document?c=us&l=en&s=gen&docid=DSN_ED7E496941DE94A4E030030ABD623736&isLegacy=true

the phone service changed my phone number.

hi

remove both exhaust mufflers and clean them of carbon deposit.pay attention at the screens from there(if they exists).try again start the engine

regards savumihai71

You probably have it in the fax/tel or TAD mode. Press the butoon on the top right side of the keyboard marked "mode" until the light above it is on "fax" only. This mode (fax/tel) is for phones/faxes hooked to an answering machine. The "fax" mode puts in into the direct answer mode as a fax machine.

turn off ECM (error correction).
then if problem persists, slow down the fax speed to 9600 bps.
this problem always occurs with a digital or VOIP line.

Plug a regular phone into the wall jack and listen for a dial tone.

Phone cord should be connected to the LINE port of the fax.

Do you have DSL?

Unplug power cord for 10 seconds.

More investigation implies that faxing over VoIP, as I am doing, requires setting the fax BAUD rate to 9600 bps or slower. So does anyone know if it is possible to set the BAUD rate on the Dell MFP 1600n multifunction printers?

Press Function/Set, 8, 4.
2 Press Start.
3 Press Stop.