Jump starter veco 10s 300 amp

Time to replace battery

Refer to the instructions that came with charger. If you threw them away you have a problem You can go on line and download instructions.
Low Charge Alert (LCA)
On the front of the unit there is a Low Charge Alert port. There is a red plug in this port. With the plug
removed, when the battery level drops to LO, an alarm will sound to remind the user to recharge the
Jump-Starter.
The alarm can be turned off one of three ways:
•
Placing the pin back into the Low Charge Alert port
•
Recharging the battery immediately to bring it to the capacity of 10% or more
•
Pressing the battery indicator display button. If the alarm is turned off by pressing the battery
display button, the alarm will sound automatically again in approximately 1 hour.
The alarm will only be turned off permanently if the battery is in a fully charged state, or the pin is
inserted in the Low Charge Alert port. There is a storage port on the back of the Jump-Starter for the
LCA plug. When the plug is removed from the LCA port, it should be installed in the storage port on the
back of the Jump-Starter.
Charging Jump-Starter Battery
All rechargeable batteries gradually discharge when left idle, and you need to recharge them
periodically to maintain maximum battery capacity. The AC charger plug within the Jump-Starter is
designed to charge using a 110/120-volt outlet.
•
Fully charge unit to the recommended maximum and initial charge time of 24 hours. Thereafter, an
AC typical charge time is 8 to 12 hours.
•
Recharge the unit fully after each use. This will prolong the life of the battery because frequent
discharges between recharges will reduce battery life.
•
Make sure all functions of the Jump-Starter are turned off during recharging

recharges from standard AC
Use an w\extension cord

you should have a red and yellow button on one side Right above it is a small AC adapter hole for a plug in charger.. IF you cant find the cord or you lost it, You still can charge it by hooking it up to a running car red to red and black to black for 10 mins and it should give it a good charge, IF fully dead leave it for 20 mins or hook it up to a battery charge low amp like 2 amps and leave it for 5 hours and do 1 hour each month unless used to start a car.

The smart thing to do is, after using it for a jump start, leave it connected for 5 minutes and it is charged again... otherwise a normal 12 V charger will do on the clamps that go to the box... I use a 12V Stanley 25 amps when needed. But most of the time I keep it connected for 5 minutes and do not worry about it.

https://www.google.com/url?sa=t&rct=j&q=&esrc=s&source=web&cd=&cad=rja&uact=8&ved=2ahUKEwinj83Xy6ODAxUbJDQIHdnTCgcQFnoECBMQAQ&url=https%3A%2F%2Fwww.fixya.com%2Fsupport%2Ft12488256-stanley_300_amp_jump_start_system_lights&usg=AOvVaw0nZRIx7WJ53qbPpG9jwswh&opi=89978449

Go to battery spec.com look up battery jump start then click on vector jump starter battery is a TR9-12A

Stanley 300 amp jump-start system status lights don't work. only low stays on

Amazon.com: Customer Reviews: Black & Decker VEC010BD Start It 300 Amp ... Instructions note that units are already partially charged before ... Recent discussions in the Black & Decker VEC010BD Start It 300 Amp Jump Starter forum ...amazon.com/Black-Decker-VEC010BD-Start-Starter/.../B000E1HAIK - 235k - Cached