Drum not turning despite belt ok and motor ok, lots of sediment from drainage pipe

Gravel can't kill the motor. The motor is only connected via a drive belt. The only thing gravel can do is damage the pump as the gravel and water runs past the pump impeller!

If it doesn't turn in wash (low speed), but it does spin in spin mode (high speed), my guess is the the belt needs tightening or replacing.

Check the drum motor power supply if its OK then problem can be in the control box try to figure out the trouble. And trouble shoot it

The carbon brushes on the motor may be worn out.

hello the belt could have snaped if ok check the brushes on the motor 2 plastic blocks either side of each other hope it helps

regards
shaun

Bosch WFL226 MAXX This video will show you how to change the pump washing machine
Please remember to subscribe to our YouTube channel for all appliance tutorials
a 4 THUMBS rating is appreciated for answering your FREE question.
And don't forget to like us on facebook

Hi, How old is your maxx? Have you ever experienced this before?
This is quite a common problem and can be sorted quite cheap to. You will need to take the back off depending on which model you have to access the motor! Take the motor off and then we can sort the problem.....
Get back to me....

Hi,
Does the drum turn OK by hand with the door open?
Does the motor sounds like it is turning - a variable speed humming sound?

If your answers to both are "Yes", then the drive belt may have broken or just fallen off. This will be visible after disconnecting the power and removing the top cover. If there is lots of rubber dust inside the machine and on the floor, the belt will probably need renewing.

If these suggestions do help you solve the problem, please give my reply a rating to help others judge my knowledge / guessing skills.
If they do not, please hold off on the rating and add a comment with more details so I can try to help you further. Cheers, D

I picked up a second hand unit which had the same problem.
I removed the back (philips head srewdriver and 1/4 in socket) and vacuumed all the lint from around the motor, and the vent at the back.
The motor drops our easily for cleaning (1 screw). Make sure the belt tensioner goes back in the same slot.

Mine now works as normal.

My drum stop, then I put in new carbon brushes. It works very good in 2mouth, now it stop again. Wht can be problem?