Lubricant-substitute for Mobil Rarus 427 for lubrication of Tanabe compressor (emergency only, no compressor oil on board of the ship). Is it possible to use for short period of time system oil SAE 30 TBN 6 or hydraulic oil VG 100? Please kindly advise
Looks like a four years old thread. Compressor oil has no detergent while engine oil does. I would use SAE 30 and not hydraulic fluid
Hydraulic oil can not be used as lubricant oil.
1. Hydraulic oil is mainly used in all kinds of hydraulic oil systems. Its viscosity grade is determined by the working condition of hydraulic system. The additives used are anti-oxygen, anti-rust, anti-wear and so on, which are quite different from internal combustion engine oils. Therefore, we must not use hydraulic oil as oil.
2. In the field of application, hydraulic oil is mainly used in the field of industrial lubricating oil, while oil is generally used in the field of automobile, which is some difference in the field of use. From the external color point of view, the hydraulic oil color is generally golden transparent body, while the oil is relatively blue in color.
3, from the point of view of manufacturing, the general hydraulic oil is a semi-finished oil, they have a remarkable characteristic of high pressure resistance, the manufacturing process is slightly worse than the oil. One of the most remarkable features of oil is lubrication. The internal microstructure of oil is smaller than that of hydraulic oil, and its viscosity is generally higher than that of hydraulic oil.
https://www.dieselgeneratortech.com/generator-sets/How-To-Choose-Lubrication-Oil-For-Diesel-Generator-Set.html
SOURCE: overheating? burnt oil smell
There is a seal between the compressor and the motor that in failed condition will leak oil into motor windings causing burnt oil smell. Some hitachi compressors suffered from failed valves or head gasket causing extra heat but not oil smell. These compressors also have a thermobreaker built into the windings that when failed will prevent motor from starting or would start and run for only a few moments then open. This part is not replaceable. enjoy
SOURCE: owners manual ruined. what type of oil do i fill w before use
you should be able to find the manual online if it's available if not Sears would I'm sure be able to tell you.
SOURCE: HUSKY PRO AIR COMPRESSOR 30 GAL I NEED TO KNOW HOW
Depends on what plan it was made in...
If you have the glass type sight... Only to the max you can see (top of site), then run it for a few mins, let it sit for a few more mins then add more if the level is near the bottom of the sight glass.
If it's the dipstick model that pushed in, there will be an upper and a lower level mark (holes, or checkered section) Keep it between the top and bottom marks.
Finally if it's the older screw-in type, remove the dipstick and wipe it. Set it back in BUT don't screw it in. Keep within the range on the dipstick from that position. Then of course screw it back in/
Good luck
SOURCE: My Hitachi EC12 builds pressure, shuts off, then air escapes
the problem is in the check valve where air enters the tank.when leaking it lets air pressure up to the air piston causing the motor to stall upon restart.replace check valve.average cost of part 15 to 30 dollars.simple fix
SOURCE: Gas/oil ratio mixture; chain oil lubricant
Call their customer service at 1-800-242-4672 there are options to choose for gas/oil ratio mixtures info.
447 views
Usually answered in minutes!
×