The machine just shuts off with no error codes. When the power buton is selected and any cycle you hear the door lock when start is pressed and as soon as the drum begins to turn it clicks off; no codes. Sometimes is will start and run without issues for 5-10 minutes and then just shut off; no error codes...
SOURCE: Machine won't start, lights are all on and ready to wash
this may be due to heavy load , if there is heavy load then also the machine will not start but the lights will glow
SOURCE: LE ERROR CODE ON LG WM-2277HW
Don't call service, they will rip you off!
See posted titled "LG Tromm WM2277HW will not spin"
SOURCE: I have a WM2277HW LG washer. I launched a cycle
Replace the hall sensor located in the back. If that doesn't fix it, then you have a problem with the rotor and stator.
SOURCE: My LG Tromm front loader
The problem appears to be the direct drive motor located at the rear of the machine. It seems that the drive motor draws too much current when the machine is loaded during the spin cycles. Unplug the machine then remove the rear access panel to access the drive motor and remove the bolt securing the rotor to the drive shaft. Remove the rotor then check and make sure the electrical connections on the motor windings and the Hall sensor are snug and tight. Reseat the connections several times to clean off possible corrosion and dirt built up.
Measure the resistance between each two of the motor winding terminals and it should read almost equally at around 5 ohms to 15 ohms. Also measure the resistance between each these terminals with the windings core and the cabinet which should read infinite (open). Any significant discrepancy in the readings compared to the normal values is an indication of a motor windings problem, replace the stator.
Check the motor and Hall sensor connections to the main control board and ensure they are snug fit if the connections right at the motor terminals including the winding resistances are all good. The problem is with the main control board malfunctioning if all else turns out good; wire harnesses, connections, and motor windings. Replacing the main control board is then the only option.
You
don't have to accept or reject this post in order to add comment or
information. But accepting the solution
should you find it helpful and/or informative will not stop you from
posting comments or additional information. You can still communicate with the expert should you need further advice regarding the issue stated herein.
SOURCE: For about a month my LG WM3677HW began to not dry
Hello, My Name is Mike, please do me a favor and check out this link I gave you below to see if you can dissect some of your issue of the symptoms, and this might in its self help you with this problem. Please let me know it this helped some. Thanks Mike
Please copy and paste this link into your browser.....
http://lgknowledgebase.com/kb/index.php?View=entry&EntryID=6333
162 views
Usually answered in minutes!
×