Question about Reddy Heater-170,000 BTU Kerosene Deluxe

1 Answer

I need a manual or picture of how to fix my ignator

Model RC165Ct

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    New Friend:

    An expert that has 1 follower.

  • Contributor
  • 1 Answer

Looking for the same diagram

Posted on Jan 09, 2014

Ad

1 Suggested Answer

Anonymous

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Installed a new ignation switch with the keys that don`t have chips. Motor turns but won`t crank. Also keys won`t come out of the ignation unless thr ignation is unplugged.


It's not going to start without receiving the right code from the chipped keys. You've only swapped out half the anti-theft system. The rest is in the software. No way to get past that. Fix it right or you'll be walkin'

Jul 11, 2017 | Cars & Trucks

1 Answer

Put in new ignator will not lite


Did you follow installation instructions on the ignitor? The pilot light may have gone out. Try turning the gas off to the dryer for a couple minutes and then following the pilot light lighting instructions for the valve assembly. Youtube has many good videos on this as well.

Dec 01, 2014 | Maytag Dryers

1 Answer

INJECTORS WONT OPEN FOR MY FORD EXPLORER 2002


need to service the injectores or better replace them

Nov 07, 2017 | 2002 Ford Explorer

1 Answer

My ignation fuse is blown. i'll replace new one it blown again. what is the coz and how to fix it?


The short answer is something is pulling too much amperage thru the circuit.
You would need to find out what is in that circuit then check for shorts to ground.

Feb 16, 2013 | Cars & Trucks

1 Answer

Alert/Alarm for key/headlights no longer sounds


The owners manual should help shed some light on this problem. The car may be somewhat programable for the alerts and warning systems. You may also need to lubricate the door button that senses the door is open and closed. Good luck.

Dec 10, 2012 | 2003 Honda Civic

1 Answer

Where is the distributor cap on a 1998 kia sportage?


the Kia does not have a distributor, let alone a distributor cap, the engine is equiped with a ignation coil at each cylinder, there is a crankshaft and camshaft sensor that send signels to the onboard computer system then the computer sends the signals to the ignation ignator it then sends the signals to the coils at each cylinder. a much better system then a distributor.

Jan 04, 2012 | Kia Sportage Cars & Trucks

1 Answer

Hi my ignation is not working because the fuse inside the ignation box is burnt what is amp of the fuse so i can replace if,where can get the fuse from.thank you


Hi,
That is not that hard to fix and you can easily buy the parts yourselfonline...

Here is a tip that will help you with the online buying...

How to Buy Appliance Parts Online

Here is one site that I recommendhttp://ping.fm/zJDAM
heatman101

Aug 26, 2011 | Smeg 23 in. SE64 Gas Cooktop

2 Answers

Maytag stove MGS5770ADB - Burners will not light - ignators


The spark module should be behind the rear panel of the range, or behind the bottom drawer, mounted on the interior back wall. If you go to searspartsdirect.com, the part is listed as item number 22 under the "Gas Controls" heading. The part number is 74004283. Just type in your model number and follow the links on the next page. There are helpful drawings to assist you. If in doubt, trace the wires from the the surface igniters and they all will lead back to the spark module. I hope this information helps you. Let me know if you need further assistance.

Jun 21, 2008 | Maytag MGS5770 Gas Kitchen Range

1 Answer

Oven Ignation would not Stop flickering after ignation


This is usually due to the "brain" of the stove going bad, better known as the control module... not an expensive fix if you can find the part and due it yourself... you can locate it iether in the back right corner when you lift the stove top or it's under an access panel below your broiler drawer depending on model.

Jan 15, 2008 | Brown Stove Works TM110-3 Gas Kitchen...

Not finding what you are looking for?
Reddy Heater-170,000 BTU Kerosene Deluxe Logo

Related Topics:

51 people viewed this question

Ask a Question

Usually answered in minutes!

Top Reddy Heating & Cooling Experts

Paul Carew

Level 3 Expert

3489 Answers

Superior Maintenance

Level 2 Expert

67 Answers

Brad Scarpetta

Level 2 Expert

104 Answers

Are you a Reddy Heating and Cooling Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...