Kenmore 80 Series Heavy Duty washing machine suddenly will not drain. Tried different settings, nothing.

belt mayb

Check the following before replacing the timer.

1. Clogged drain line or water pump
Check to see if there's something stuck inside the pump or the drain hose connected to the pump (pump is usually located at the bottom and towards the back of the washing machine).

2. Water Pump
If the drain line isn't clogged, you may have a problem with the water pump such as a frozen pulley or a broken impeller. If that's the case replace the water pump. Note: if you have a belt driven washer, check the belt(s) for cracks, as this would be a perfect time to replace the belt(s) if needed.

does it drain?did you check the lid switch?

Replace the timer.
This is a neutral drain machine. If there is no natural pause in the timer at the end of the rinse cycle the timer is bad.

Dear cbringer,
I have the same washer. I have had the same problem with it. It's the timer module. You can get additional help from http://www.repairclinic.com.

Hope This Helps,
Jay

If it drains and won't spin you have to replace the direct drive coupling.

Check to make sure your lid switch is working.

does it agitate?check your coupler.

I have Serial # CF2467934 Model # 92588210 Kenmore Ultra Fabric Care Heavy Duty 80 Series. The top agitator is stripped out, how do I take it out to replace it?

where is the lint trap located