Flashing light.....how to get it to stop and get pad to work

heating pads are NOT repairable. toss it away and get a new one.

ck fluid if low add pump pedal if still on ck with flash light the brake pads you can see them through wheel if pads look real thin take in for brakes if pads ok and fluid ok and brakes seem to work take in as soon as can to be safe the brake light comes on only if fluid is low pressure is low or pads are low the abs system covers the rest.

START/RESET status indicator light flashing

You have pressed the indicator light flashing START/RESET pad while the START/RESET dishwasher is running. This will cancel the cycle. The light will stop flashing after the dishwasher drains (about 90 seconds).

• Press the pad once to start the dishwasher. Press the pad a second time when the dishwasher is running only if you wish to cancel the cycle.

Power to the dishwasher was turned off while a cycle was running and power has just been restored to the dishwasher. The blinking lights indicate that the dishwasher is draining the potential water inside.

• The light will stop flashing after the dishwasher drains. A new cycle will start automatically.

Good luck

Your printer needs to be reset. Flashing lights means that your waste ink pad is full when that happens printer stops working to prevent flooding of waste ink inside your printer. Google search for a resetter program for epson d68. You need to replace the waste ink pad or create a tube line to divert the waste ink out of the printer. Good luck.

I just had this same problem, and came here to figure out what to do about it. Turns out I had the CD/DVD tray in the out position, so all I had to do was flip the switch to stow it and the flashing lights stopped. Maybe it will work for you as well.

check if the lights on the pad are flashing you need to sync the pad

to do this you hold the red button inside the battery casing and the

red button inside the SD slot casing and wait till the light stop flashing

and go to the light corresponding to your controller

that is it it should work and be synced for every game

That orange light means that you must have your braking system check...most probably it's the pads wear indicators that are earthing warning you that the pads are worn.

If both lights are flashing, it means the Waste Ink Pads in your printer are saturated with ink and the waste ink "protection" counter has exceeded its limit. The Waste Ink Pads should be replaced as soon as possible. You can restore your printer to a working condition immediately by using the SSC utility - download from

http://www.ssclg.com/epsone.shtml

and use it to reset the Protection Counter. This will stop the lights flashing and restore normal operation.

However, remember that eventually ink will overflow from the waste ink area and make a dreadful mess, so you must change the waste ink pads before this happens. This requires the disassembly of the printer.

If you decide to have a go at replacing the ink pads yourself, report back and I will provide further help.

If both printer lights are flashing, it means the Waste Ink Pads in your printer are saturated with ink and the waste ink ("protection") counter has exceeded its limit. The Waste Ink Pads should be replaced as soon as possible. You can overcome this problem temporarily by using the SSC utility - download from

http://www.ssclg.com/epsone.shtml

and reset the Protection Counter. This will stop the lights flashing and restore normal operation. However, remember that eventually ink will overflow from the waste ink area and make a dreadful mess, so you must change the waste ink pads before this happens.

If you wish to pursue this matter further, report back.

Your control panel is getting ready to quit. Mine did the same thing, I ignored it and now nothing on the touch panel works. About $150.00 for the part.