- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Check and replace damaged component/s at its horizontal scan output section circuit. Check the LOT (Line Output Transformer) too for damage. Replace the horizontal scan output transistor. Check the input voltage to LOT. If the voltage is absent check the feeder resistor; if any. If you wish to get some details; check the site linked here. Pull up older posts. http://electronicshelponline.blogspot.com/ Type in this key phrase " my service table today " in the search box at the top right of the the home page, to get gathered some pages which has the details of practical experiences of the author of that site. The search result might display about 20 Nos of related posts. Press the "All posts" at the bottom of the list, then you can select them one by one.
This is a problem coming from your signal cable(cable from system unit to monitor). All you have to do is to change it. If it still doesn't work, you have to change your monitor
replace the tempt prob as if the control was bad the other oven would not respond . there is probe in each oven to tell the prosser what tempt they are running at . if one prob failes no info is sent to the prosser . ( replac it mm .. )
there are many cause for it 1/vj has gone change it to check it.2/ wp/vista progrram is damage repair it 3/ ram may be damage change it to check it. mother bord may be damage change it to check,prosser may be damage change it check. last u may change high graphic- press f8 then u can correct require graphic....thanks
install orinal fan of intel or cpucoolar .............and check your prosser is cool ...ok and all problem in mother board in prosser panal .................
for a normal upgrade just follow your manual of your mother board or just go to coomputer hardware shop and ask for the latest processor they could give for a motherboard which you have (give them the model number)
×