Blomberg WM87120 NBL00 Front Load Washer shut off mid-load and will not not turn back on. Brand new, only done a few loads.

This machine is by far the worst I have encountered for finding parts. I just went through 18 pages and there was nothing that looked like a control panel. Most sites has a Parts Schematic by the area of the machine the parts are in.

https://www.google.com/search?q=blomberg+washer+wm87120+nbl00+control+board

Manual

https://www.manualslib.com/manual/622179/Blomberg-Wm-87120-Nbl00.html?page=19#manual

..

so do I,try cleaning filter first! if there is one,it would be on bottom front of machine turn it anticlockwise to undo it.clean and refit.get back to me if that dose not work.bye,eire

Under warranty - contact retailer or manufacturer - check user manual or receipt for procedure.

I’m happy to help further over the phone at https://www.6ya.com/expert/donald_f2ed37026a3ac881

replace door inter lock

Remove top of washer by removing screws in back of top. You should see the tech sheet. Use this to retrieve any error codes.
A common problem with these is a bad door switch. (The part the strike goes into. If this is the case you should come up with error code for it.

We found a way to reset the computer and solved the problem.
1. Press and hold pause turn off machine and turn back on holding pause all the while.
2. This should reset the computer. All lights will light up on LCD display.
3. Release pause button. Turn off machine, turn back on and begin a new wash cycle.
woo hoo!

Hello Mary Fortner - It means that the washer has been paused; the cycle has been interrupted. Either the "Pause/Cancel" button or "Start/Pause" button has been pressed. To resume wash - press "Pause/Cancel" or "Start/Pause" once. If this does not prove to be successful please turn the breaker to the unit off for 5 minutes. Then turn the breaker back on to the unit, and retry the cycle setting again.

I have Blomberg WM87120 NBL00 Product code 717518110 and had flashing Lock in display. Bought and installed new lock and no change. Display still flashing lock. Used following procedure and every is working now.
Press pause button and hold down while turning off machine.Continue to hold pause button and turn power back on. If numbers come up on display make note of them for future reference. Release pause button and all lights on display will light up. Turn power off again and then turn back on. If machine was in a cycle it should end it and then return to normal operation. .Dont know if new lock made a difference. Try the reset procedure first.

My guess would be the bearing going bad. Big job to replace but not impossible. If washer is old, I'd buy a new one instead.

doesnt this model have the cancel button by the start button.......if so........switch on then hold cancel for 10 seconds...........

cheers