SHARK IRON WITH TANK.GREAT BUT SUDDENLY STOPPED.

take it back to were you got it from i think the regulator has just packed up

All the settings should be visable..
Check the return policy where you got it..
I know that Wamart has a 90 day return on these type of things..

Hope this helps !!
Rate me good ;o)

shark website for instructions and number

perhaps the thermostat is sticking.as irons are cheap to replace i would try cleaning /soaking the tank to remove lime scale. or strip the iron down checking thermostat and conections.

take it back to the store and tell them what has happend the only thing i can think of is that one of the wires has come loose within the cable

Bought my Shark G1400Z iron about a year ago. The iron caught on fire. Luckly I was only out of the room for a few seconds. What can be done about this?

The cost of repair is more than the cost of a new one. Therefore, trash it and buy a new one.

your heating coil probally went bad its alot cheaper tp just buy a new iron

SELF CLEANINGIt is important to “Self Clean” the iron at least every two weeksto remove scale, calcium, etc. The harder the water, the more often the iron should be self cleaned.1. Set the variable steam control dial to any steam position.2. Fill the water tank up to the “MAX” level.3. Stand the iron on its heel. Plug the iron into the electrical outlet.4.Press the electronic temperature control button until you get the “MAX” temperature setting on the display panel and wait until the iron heats up and temperature setting light stops flashing.5. Turn the variable steam control dial all the way to the right to the self-cleaning position and hold the iron horizontally over the sink (Fig. 8).6. Boiling water and steam will now be ejected from the holes in the soleplate. The impurities and scale are washed away with it. 7. Move the iron back and forth as this happens.8. If there is any water left in the water tank after the iron stops steaming, just empty the remaining water in a sink following the instructions for emptying the iron. 9.Turn the variable steam control dial to the “0” position when the water tank is empty.10.Place the iron back upright on its heel to cool down before storing.

how do you replace the light bulb on a shark euro-pro iron?