I bought a new property which has a Roper Dryer Model REX4635EWO and a Roper washer model RAB5232EW. NO MANUALS!

when empty turn it upside down it should have three springs holding the washing machine to the frame
one mabe missing if that not the prob try leveling the load and make sure the leveling leggs are all
toutching the floor good luck

Hi,

There can be many reasons why your dryer will not start or turn...

The most common causes are the belt breaking or jumping off, or the motor going bad...

Here are a couple of tips that I wrote will help you to figure out why your dryer will not run...

Dryer Repair - The Dryer is not Turning

Dryer Repair - The dryer will not start


heatman101

Both these manuals are available at managemylife.com. Just type in the model numbers you provided under the "Manuals" link and you will find them in .pdf (Adobe) format that you can download or print for FREE. I hope this helps you.

Are you sure your dryer model number is correct? The closest model number I could find is "WED5800SW0" If this is your model number, both the washer and dryer manuals are available at managemyhome.com. Just type in the model number under the "Manuals" link and they are available in a .pdf (Adobe) format that you can print or download for FREE. I hope this helps you.

NOTE: The last digit on these serial numbers is usually a zero "0" and not the letter "O".

Watch the video:

If you need further help, I’m available over the phone at https://www.6ya.com/expert/craig_3fa289bf857b1a3c

no belt, drive coupler it's probably broken and needs to be replaced. but if its the drive coupler it wont wash either so recheck it.if it still washes then check tub for object through holes jamming tub..you should be able to force the tub around by hand.

ck door switch

Yes UNPLUG and open the back of the unit on the bottom right side you will see the element in a heat chute that model has what I call a half element it mounts on the bottom portion of the chute just remove the 1/4" screws and the high limit stat and you will see how the new one goes on

I thinkl you can order the manuals from www.sears.com under the parts tab enter your model # also if it is an electric dry it is 220v with a neutral leg check with the local electrian to see if the power there is phased..Hope this helps
PS::The washer and the refrig will work on the tranformers