The door is locked and the Finished/Spin and Wash Lights are all flashing alone with a beeping tone. This is in ALL wash modes except off.

Is water turned on? Make sure screens in hoses and valve are clear of debris. Make sure hot and cold hoses aren’t reversed.

There should be a way to enter the washing machine into service mode to view an error code. Check your user manual and then you should have your answer!

replace the motors brushes check the filters
and clear any bits of bra wire etc

then reset the machine {usually hold power in and apply the mains}

Try restarting it, make sure the load isnt to heavy, if that does not help, call a local repair man.

First, clean the drain filter and try it again. Post your results back to me.

hi something similar has started happening to our washer, after the initial wash starts the machine doesn't do anything for a while then the red door light flashes on and off very quickly as does the 1st and 3rd green wash cycle light?

It is giving out a fault code,
Of the 8 wash progress lights, tell me witch are on,
I will tell you the fault code and info on how to fix.

I just had this problem! To get the clothes out, open door manually (follow answers on other threads here about opening toe panel and gently pulling down on door release). But as it turned out, I didn't need to remove the clothes, and now my washer is working again.

A local repairman gave me this advice over the phone. Make sure dial is switched to off. Unplug your machine, then plug it back in. Hold down the rinse and delay buttons with one hand. With the other hand, switch the dial from off to cold or warm or whatever cycle you want. All the buttons flash a few times, then just the start button flashes. The second time I tried this, my washer worked afterwards. I've done several loads today with no problem.

hello mam please check the timer and internal wiring.

The latch might be an issue . Move the dial on pump mode . Try activate the door lock with a screw driver move it to the right and should activate the machine. If that works then the latch is the issue and can easily be repaired by removing the door.