Maytag PAV2300 Top Load Washer Logo
Posted on Mar 23, 2009

Maytag SAV 3652 AWW Washer: During spin cycle, burning smell occurred while making unusual noise. (For months, major squeaking during agitation).

  • Heather Miethe
    Heather Miethe Mar 26, 2009

    My washer made this noise like it was having a real hard time spinning clothes when I would go in and move the middle agitator over to the corner it would spin normally. Also when it would make that bogged down sound it would smell like burnt rubber or something. Now my daughter overloaded it and it won't spin out.

×

1 Answer

Larry Burke

Level 1:

An expert who has achieved level 1.

Corporal:

An expert that has over 10 points.

Mayor:

An expert whose answer got voted for 2 times.

Problem Solver:

An expert who has answered 5 questions.

  • Contributor 16 Answers
  • Posted on Mar 24, 2009
Larry Burke
Contributor
Level 1:

An expert who has achieved level 1.

Corporal:

An expert that has over 10 points.

Mayor:

An expert whose answer got voted for 2 times.

Problem Solver:

An expert who has answered 5 questions.

Joined: Feb 04, 2009
Answers
16
Questions
0
Helped
5339
Points
29

Bad water pump. Replace water pump.tip machine back,Look under machine, remove belt, turn pump by hand, if not spinning freely replace pump.

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

Admiral washer model AW20N2V making a clicking sound...

call manufacturer. heard there was a recall... for dangers of fire.
0helpful
1answer

Maytag Performa PAV920AWW makes squeeling sound when agitating/spinning. Water does not drain completely during spin.

Sounds like brake is partially engaged. There is s kit that may fix that. Part # 12002213.
0helpful
1answer

Washer has been making an unusual amount of noise / burning smell

remove the door and screws on opposite side and the front comes off. Then the top will flip up.
Eric
0helpful
1answer

1 yr machine. Won't spin but has burning smell

The reason to this problem can be due to the
brake rotor.It need's to be replaced.
0helpful
1answer

Very loud final spin cycle with burning rubber smell

Hi Mcbride2

It could be one of 2 things. 1 the belt. or 2 the main seal and bearing. i recomnd to get a tech just to make suer.

brent
0helpful
1answer

NAV5800a top loader washer

The inside of your agitator became worn, and possible strip out the spline that allows the agitator to properly grip the shaft. The loud noise mustly occurs during the spin cycle. If you hear this loud noise your load of clothes may have become unbalanced. Stop the washer and redistribute the clothes, then re-start it.
0helpful
1answer

Maytag legacy series washer top load-squeaky during wash and rinse

very possible if squeaks in agitation top springs that hold tub needs greased under spring & plastic shield under spring. had same problem on big front loaders whirlpool
1helpful
1answer

Maytag Atlantis shut down during rinse cycle.

Contacted a local repair shop. They told me that if I got it spinning again, the motor was most likely ok. It is protected by a thermal switch that turns it off when it begins to overheat. The smell was to be expected as it was overheating; the difficutly restarting was because it hadn't cooled off enough yet. We have now used it a few times for small loads. Still getting a smell, but the wash cycle is completing ok.
1helpful
3answers

Squeaking Top Load GE Washer

I bought a new GE Washer GTWN5050MWS yesterday. From the first load it squeaked each time the tub moved back and forth (no agitator in the infusion type) It is a quick squeak and kind of resembles a cat getting it's tail under a moving rocking chair. I checked the entire owners manual and it describes several noises and not one of them describes what my new washer is doing. It does not make this sound except for when it is in the wash cycle. Spinning is quiet, and during the agitation of the rinse cycle it is a much more subdued squeak. But during the wash cycle it is not acceptable.

I called GE this morning and they told me it was normal operation for all infuser types of their washer to make this noise. Tomorrow I will be taking it back for a full refund.

We purchased this machine because our 2-year old front loading GE washer broke down (discharge pump I think) and to get it fixed usually takes a couple of weeks. We thought it might be better to have a 2nd washing machine instead of paying the laundry mat. It took a month to get the last one declared unfixable in 2008. Maybe I was wrong. But this is very bad luck to have a brand new washing machine squeak so loud out of the box.
2helpful
1answer

"howling" noise during spin cycle (still there after changing burned off belt)

Travioso, there was two service flashes out on this model concerning the seal and bearing which means they had an issue with this washer. The howling noise you are hearing is the bearing and will need the new designed triple seal and bearing kit. This should be covered under your warranty, I believe it is 5 years. The numbers for the service flashes are TDL-0048A-B. Call Maytag and inquire about these service flashes, these should be covered. Catriver.
Not finding what you are looking for?

696 views

Ask a Question

Usually answered in minutes!

Top Maytag Washing Machines Experts

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

Brad Brown

Level 3 Expert

19187 Answers

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Are you a Maytag Washing Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...