My Canon Faxphone L80 will receive but will not send.

The receiving fax must have legal size paper available and their machine set to auto reduction.

Describe 'Lots of noise'.....was it static? Or high pitched varying tones (also known as handshake) Normally the two beeps are after the 'handshake tones' which means that the fax is awaiting an answer from sending machine. If you don't mind, email me your fax number so that I can hear exactly what you are hearing. [email protected]

Page 9 in this setup guide to program fax recieve mode for your Canon Faxphone L80.
http://gdlp01.c-wss.com/gds/0300000537/FAXPHONE_L80_Set-Up_Instructions_EN.pdf

Make sure that the telephone line from the wall is plugged into "LINE" and not "PHONE" on the fax machine. You might also call the fax number from a different phone to see if you can hear the fax tones.

There is a little rubber pad where original feed in. Look at it on edge and you'll see it has concave wear. Carefully remove black plastic hold down and flip rubber pad over. You'll have to make a new hole so it will lay flat.

will it send? It has been put into "manual receive" or "telephone" mode......set it back to "auto receive".

Hello sir; Try to make a copy on this machine, if copy coming out good that's means the problem happen on remoted side.

To send a fax you do not need to enter anything into your fax. You have to make sure that you connect the telephone line to it's desgnated connector. You dial a number to send as if you are calling form a normal phone. If you ever get a ringing tone press start. You can enter any data trough the data registration after you make sure your fax is functioning properly.

here is the manual

http://www.retrevo.com/s/Canon+L80?rt=tr&p=http%3A%2F%2Fwww.usa.canon.com%2Fconsumer%2Fcontroller%3Fact%3DModelDetailAct%26fcategoryid%3D127%26modelid%3D9986

Most probably you have the machine set to "manual receive." Change the receive mode to "auto" or "Fax" mode.