My kenmore washing maching door is not opening

"Fdl" is a door latch error code. This is an indication of either a defective door latch, door catch, defective Central Control Unit (CCU), or an interconnecting cable problem between the two. The following link explains how to troubleshoot the problem:

http://www.fixya.com/support/r4490349-fdl_error_code


I have included parts resources, and the steps required to replace any defective parts. Prices vary between sites, so shop and compare. the first three sites listed also have helpful exploded view parts illustrations to assist you with locating and properly identifying the parts you may need.


Read through the information provided and post back with your complete MODEL NUMBER if you have questions. I hope you find this information helpful.

open the bottom panel by unscrewing 3 screws. reach up towards the door lock and pull a level to manually unlock the door.

"f6" error code means that there a miss communication between mcu(motor speed control board) and ccu(central control unit). i recommend you to ohm out the motor. most likely its your motor speed control located at the bottom left of the washer good luck. replace the motor speed control board and you should be all set to go.

Pressure Switch failure - remove the hose at the top of the machine, and blow in it to clear moisture/buildup.
If not - replace the Pressure switch.


Thanks for using FixYa - a 4 THUMBS rating is appreciated for answering your FREE question.

your mach depending on model and cycle selected has a 3 to 5min "add a garment" feature.that means in the 1st 3-5mins of cycles when add a garment light is lit you may hit pause button once and the mach will stop and unlock door.after add a gament light is off,if u hit pause the cycle the mach will drain water and reset cycle..hope this helps

sounds like a bad water inlet valve stuck open and permitting watertto enter even though not on, untill you replace the valve turn off water between uses part number 8181694

Go to searspartsdirect.com and type in your model number. The door latch assembly can be found under the "Door and Latch Parts" heading as item number 7 (part #8181700). If you need instructions on how to replace, just follow this link:

http://www.fixya.com/support/r587965-door_latch_replacement_fdl_error

If you do not wish to purchase parts online, use the part number provided and go to your nearest appliance parts retailer. I hope this helps you.

Another posibility is the door lock switch is broken. When you open the door, on the middle right hand side there should be a small pin sticking out from the washer that the door pushes on.

The door will stay locked if the machine did not drain properly. Try running a Drain & Spin cycle.