Door locked light flashing when door is closed

It seems like your washing machine is experiencing a common issue after a power outage. This could be due to a disruption in the machine's cycle. To resolve this, try the following steps:

1. Reset the Machine:
   • Turn off the washing machine and unplug it from the power source.
   • Wait for a few minutes (around 5-10 minutes).
   • Plug the machine back in and turn it on.
2. Check Door Lock:
   • Ensure that the door is securely closed and the lock is engaged.
3. Restart the Cycle:
   • Select the desired wash cycle and press the start button.

If the issue persists, it might be helpful to consult your machine's manual for specific troubleshooting steps. Additionally, power fluctuations during the outage might have affected the machine's electronics. If the problem continues, consider contacting the manufacturer's customer support for further assistance.
Remember, power interruptions can sometimes cause electronic appliances to behave unexpectedly, and a simple reset often resolves such issues.

Try first putting the control on 0 , then unplugging power cord for ten minutes, then plugging it bac.

If this does not work try restarting the cycle at any point and leave the cycle to complete, then you try openoing the door.

Try cutting the power again for 10 minutes. If it doesn't fix it, you will need a service call.

try door inter lock

F06 - Door lock fault
Issue: Washing machine door cannot be opened or closed/when the door is closed the machine the programme will not start.
Advice: If your washing machine door will not close, please check for any obstructions in the door lock.
OR,
Switch off the device. Disconnect power. Wait about 3 minutes.
Open the door, then close. Reconnect device to the network.
Start device.

Cause: Door lock fails to close / open door lock triac open / closed,
frequency signal fault

Dado

First, are you sure there is power to the unit? Check the breakers and post back.

Sounds like needs new door interlock swith Cost around 15 pounds.....Simple to fit

hi
check the spring on the door handle/catch,the easiest way to check this if you close the door and it indicates that the door hasnt locked,push the inner part of the handle towards the machine,if it locks then the spring is worn.(this is more commen than the interlock).

First measure the door lock, make sure it's fine, then ensure that there's current flowing towards the door lock. if it'll trip all the electricity out you'll need to ru very close inspection or to replace the main circuitboard

Update me about your progress

f01 is a motor short circuit. you will probably need a new one and maybe the circuit board that powers it if all the lights went out unless the fuse is gone.