My Whirlpool Gold Ultimate Care II works fine going thru the normal wash, rinse and spin cycle. After it stops for me to remove the clothes to the dryer it starts on the next cycle all by itself. ( I have to be there when the machine stops or it rotates around the knob to the next wash.)
Replace timer..onthejob
Going through to the next wash not na normal function, perhaps the machine is advancing to an extra rinse cycle?? this EXTRA RINSE will start after the normal wash is complete, i would check your dial settings perhaps some one has mistaknely switched extra rinse "ON". if htis os not tyhe case the n i would jave to blame a faulty timer mechanism and you would need to replace the timer
SOURCE: Ultimate Care II - Rinse Cycle does not start
sounds like a lid switch problem. is there a clicking noise when you open and close the lid?
if not then the lid switch may need to be replaced; inexpensive.
this could also be caused by a bad timer.
also try a different speed for the rinse cycle, it may be a bad motor and it is not going into a certain speed. instead of gentle or slow speed try fast or normal, something like that.
805 views
Usually answered in minutes!
×