OK you washing machine genius folks, here's my problem:
Kenmore Series 70 Washing Machine (Top Loader)
Washes, agitates, drains, but when the spin cycle tries to start, I hear the motor engage, but it won't start spinning...until I open the lid, and close it again. Then, no problem.
Switch? Motor Coupling? Help!
LID SWITCH
If you need further help, I’m available over the phone at https://www.6ya.com/expert/elite_9cbd96cb0728162b
Timer is defective. Your unit has a netural drain. When finished agitating, the shuts down and then starts up reversing to drain and spin. On the initial reverse start, the water drains without the transmission spinning. After a timed period 3-4 minutes, the timer is supposed to pause, stopping the motor for a few seconds. When the motor stops again, the transmission shift to the spin cycle and when the timer resumes power tothe motor it should spin. You are doing the same thing when you lift the lid...stopping the timer and then the tranny shifts and when you set the lid down, the washer spins. Replace the timer.......
1,004 views
Usually answered in minutes!
OK, yeah, the thing isn't exactly ruining our lives...but having to go in and start the spin cycle every load kinda...well...um...sucks. ;-)
Bump. Solutions to the top 4 current unanswered questions are easily available in previous solutions.
AHEM. Come on, folks, this should be easy for anyone claiming to be an expert....
Exactly the same problem as described above. I guess I'll get a timer or find another washer on craigs list.
thanks
not the switch if the motor continues to run, not the motor coupling if it is agitating. does it spin while it is in the rinse cycle? im thinking clutch or gear case prob.....
×