Where can I get Braun MULTIMAG SlideScan 4000 repaired?

Are you letting windows find it or are you pointing the installation to the cd software disk?

braun series 3 combi 30B foil and cutter pack (7000/4000 series) for men electric shaver TriControl braun 4745 type 5714 parts.

You must be careful when ordering Braun '4000 Series' foils because Braun has made two different 4000 series shaver types that do not use the same parts. For this reason you must use your full model number or type number to ensure that you select the correct parts. If you are having difficulty locating this number, see video at the link below from shaveroutlet.com

http://shaveroutlet.com/locate_model_number_tutorial/

Once you have found the correct number, you can properly select the correct parts. Below, you will find links to both types of 4000 series foils. Match your number to the list of compatible models on the item pages to select the correct one

http://shaveroutlet.com/shaver-replacement-parts/braun-7000-series-syncro-4700-series-tricontrol-foil-p-349.html

http://shaveroutlet.com/shaver-replacement-parts/heads-foils-and-cutters/foil-fits-braun-4000-series-flex-control-twin-control-p-145.html

If you are in the USA send it to Braun service at:
HP Marketing Corp. PO Box 715 16 Chapin Rd. Unit 908 Pine Brook, NJ 07058 800-735-4373
Otherwise check the factory web site for Braun service in your area. www.braunphototechnik.com

The switch is part of the outer case and can be found at shaveroutlet.com. See link below

http://shaveroutlet.com/shaver-replacement-parts/braun-syncro-body-housing-select-models-p-811.html

To replace, you will need to gently pry off the cap that surrounds the cord hle on the bottom. Once removed, the side grips will pull away easily revealing 4 screws on the back. Remove screws to take the bask of case off and then lift out the 'guts'. Reassemble in reverse order

Driver available here http://www.latestdriversupdate.com/driver/36681.html

See previous fix for black lines problem is likely the same i.e fractures in the flexible cable between the scanning head and mother board, changing this cable will likely cure this fault.

Hi
lets start with what mac system you have there? the device is supported on Mac: OS X 10.1.5 or higher

Normally dark lines are a speck of dirt sticking on to the glass and when scanned continuously, it appears as a line. Clean the glass thoroughly. Ensure the slides are dust free. If the lines are appearing in different locations, it means the dust gets removed while scanning. Line in the same place could be because of glass is scratched. The above is common with roller scanners.

For fat bed scanners, there will be no scratch on the glass. It must be from the slides/documents