Washer fills with water when the machine is not running

your drum spider has collapsed, probably been noisy for a while, if its more than 5 years old its not worth repairing.

Water pump screen is plugged. Will not drain properly even though it goes into high spin.

my Kenmore He3T Stop But Remain have water on the bottom!!!
What happen

Hello,

The F20 error code means; no water was detected entering washer or pressure switch trip was not detected after 6 minutes

Many times that is caused by a blockage a pinched fill hose,or the filter screen on back of washer where hoses attach to are clogged

Good luck,i hope this helps

Gene

Hi,
The soleniod valve is bad.... here is a tip that will help...the problem you have is with the same part but the opposite problem...

http://www.fixya.com/support/r3880845-washing_machine_problems_no_water

heatman101

bad fill valve

Hello, sounds like there was a blockage in the inlet valve. May have been a piece of calcium. I would run the machine a few times if you have no other problems don't worry too much. If the machine starts filling again pull the plug if it shuts down you have a problem with the machine. if it continues to fill there is a problem with the valve. You should replace it. Mike

your hot water valve is stuck open the one inside the machine

In my HE3T, this was indicative of the water pump going out. In its 8th year, my HE3T is now on its 3rd water pump.

remove fill hoses at wall and washer ends look for a screen in hose at faucet end and 1 in washer fill valve pull and clean them be sure to reinstall screens before reconnecting..also fluch hoses out after reconnecting to faucet end and before reconnecting to washer to flush any trash/sand that be in them