Error e23 avantixx - Bosch Axxis WFL 2060 Front Load Washer

Question edited for clarity, add words, make sentences and stuff.

https://www.bosch-home.ca/en/service/get-support/error-e23-or-f23-washing-machine

https://www.google.com/search?q=bosch+series+8+washing+machine+e23

..

Frigidaire GLTF2940FS1 washer Error Code E23 ...

www.shopyourway.com > Manage My Life > Questions
Sep 13, 2013 - My washer stopped mid-cycle and emitted a burnt odor. Troubleshooting shows error code 23. I pulled the connector off the pump and have ...

Kenmore Washer (48112) E23 error code ' ShopYourWay

www.shopyourway.com > Manage My Life > Questions
Get shopping advice from experts, friends and the community! Hey all, I have a Kenmore front load washer model #48112. When I hit the start button the NO ...

[PDF]Error Code E23 Frigidaire Washing Machine - WordPress.com

https://grednandwestsign.files.wordpress.com/.../error-code-e23-frigidair...

E23 Drain pump relay on control board failed or wire off pump. E24 Drain pump relay If your. Frigidaire Washing Machine Error Code is not listed here, check Then the code E41 appeared and. I could do nothing else with the washer. The error .

disconnect the power the door unlock within 30 secound

You basically have water in the sump at the bottom of the machine, and the sensor gives you E23 error to stop a 'flood'.

Unscrew the back cover and dry it with towels and then a hair dryer and you should be fine...

You must have added extra water and overfilled the tray, or there's a leak somewhere if the problem persists.

Bosch wm code E23 what. Complint

this is a drain pump relay on the control board failure.you either need to replace the wire or the main control board

I checked my manual and could not find any results for an error e23, there is an error e20 for the reasons The disk is upside down
It is dirty scratched or wet
There's too much moisture in the air,wait about an hour and try again.
From presonel experiance these decks will not play MP3's only disks that have been burned using
the WAV. format.

E23 is a paper feed error. Check the rollers and the paper feed mechanism. Following are the various error codes for your printer:
CANNON Printers MP150/MP160 ERROR CODE 
E9 The connected digital camera / video camera does not support Camera Direct Printing
E14 The Ink cartridges whose destination are wrong
E15 Ink cartridge is not installed E16 - Ink remaining is unknown
E16 -E19 Failed to scan head alignment sheet
E22 Carriage error
E23 Paper feed error
E24 Purge unit error
E25 ASF(cam) sensor error
E26 Internal temperature rise error
E27 Waste ink absorber full or platen waste ink absorber full
E28 Ink cartridge temperature rise error -
E29 EEPROM error
E33 Paper feed position error
E35 15 USB Host VBUD overcurrent error - USB
E37 17 Abnormal motor driver error
E40 20 Other hardware error 
E42 22 Scanner error

turn the printer off and lift  the front top and move the cartridge carriage manually at the center and then on the printer.

Hi raj2006678,

The code e23 indicates a paper feed error. Check to be sure that your paper is loaded correctly and that the rollers are functioning properly.

Here is the complete list of error codes for the MP150:
E2 No paper (ASF)
E3 Paper jam
E4 No ink
E5 The ink cartridges are not installed or a non-supported ink cartridge is installed ,
or the ink cartridges are not installed properly
E8 Waste ink absorber full, or platen waste ink absorber full
E9 The connected digital camera / video camera does not support Camera
Direct Printing
E14 The Ink cartridges whose destination are wrong
E15 Ink cartridge is not installed
E16 Ink remaining is unknown
E16 -E19 Failed to scan head alignment sheet
E22 Carriage error
E23 Paper feed error
E24 Purge unit error
E25 ASF(cam) sensor error
E26 Internal temperature rise error
E27 Waste ink absorber full or platen waste ink absorber full
E28 Ink cartridge temperature rise error -
E29 EEPROM error
E33 Paper feed position error
E35 15 USB Host VBUD overcurrent error
E37 17 Abnormal motor driver error
E40 20 Other hardware error
E42 22 Scanner error

I hope this helps - please let me know if I can be of any further assistance.

Kind regards,
H2H