Main string came off, how do i restring it? - Barnett Outdoors Barnett Vortex Lite Youth Bow

Hi Gilbert,
Here's a link to your manual. Just download it and it should give you directions on how to restring:
http://www.manualslib.com/manual/976965/Tanaka-Tbc-4000.html

Good Luck!
Jim

Make a sharp bend in the line and insert it into the hole in the spool hub. Start wrapping the replacement line in the direction shown on the spool.

Take pull string housing off. Looks like 3 or 4 screws. Should be able to restring from under side. Either buy new string or if old string is long enough, just tie knot on the end. Good luck

http://lawnandgarden.manualsonline.com/ex/thread/view/idThread/162312

how to restring a poulan weed eater

YOU MUST REMOVE THE STRING HEAD YOU SHOULD HAVE TWO PEICES THE IUTER HOUSING YOU SHOULD CLEAN THE INNER SPOOL REMOVE ANY OLD STRING AND LOOK ON THE BOTTOM THERE SHOULD BEARROWS TO TELL YOU WHICH WAY TO WIND THE NEW STRING

turn trimmer upside down and pull spoolhead off wind new string clockwise

Hi
check the following links :
http://www.ehow.com/how_2241527_change-string-lawn-trimmer.html

http://www.youtube.com/watch?v=SuGfDNH6fXk

Theses are just two, there are plenty of videos out there that shows how to resting trimmers

Hope it helps

to restring it all you have to do is pop the cap of string head pull the spool out and wind your string around it in the way they say to run it.its usually on the spool wind this way with an arrow.the cap shood be pushed in and turned to unlock the cap replaces the same way

I just assume you used stronger line on an autofeed string trimmer.