When pushing the on button all the lights start blinking.
SOURCE: LG Flatron L1550S power light blinks green.
shorted components on the circuit. send it to a repair shop if you don't have experience on electronic troubleshooting!!!
SOURCE: Control panel lights up but washer will not run
Press "end of cycle" button to clear screen. Maybe your previous washer was here........drain pipe.
Check your exit hose spigot, it may be clogged. This is if your filter is all clean. There should be air for passage in the standpipe behind. Your hose should not fit airtight into the standpipe and neither too deep into it. Snaking out your standpipe would be good too. Important: height of drain hose is abt 3 feet from ground level.
Rate me pl.....if helped.
SOURCE: my lg front load washer
LE codes are extensively covered in past Fix-Ya solutions, but are generally caused by only a handful of things. 1. the " Load Error " can be a very off balanced load. 2. excessive use of soap leads to too much suds, and thus drag on the inner tub. (use 1 tablespoon of HE soap max. per load) or 3. the Hall sensor (part number 6501KW2001A) has failed. The hall sensor is rather easy to replace, and is covered by a seven year part warranty. Take the back cover off. Take the big nut off and remove the motor rotor. Remove the bolts holding the motor windings. Remove the electric plug on the sensor and unclip it from the motor winding. Snap new sensor on and reassemble. Usually takes under a half hour. On a difficulty scale of 1 - 10, it might rate a 4. This should be a Fix-Ya for your machine, and at basically no cost!
SOURCE: red blinking light when tv is turned off
if this is a 37lg30 i have brand new spare parts. the tv was never used it was dropped and the screen was damaged so i just took out the parts out. i was originally looking for some one that had a problem with there tv but a good screen like you but its easier to ship out the boards.
SOURCE: washer will not spin after pressing the "play/start" button
Hi,
There are a couple of reasons for the washing machine not to spin. Since the reason is not specific we need to to perform a couple of steps to determine the reason of the no spin.
Depending on the models the earlier models had brake shoes in the bottom of the machine. If you tip the machine over you can see them. If they are worn, they don't engage so may need replacing these were about 20 year old machines one of the problems with the newer models is that they have a cut out switch when you lift the lid if this is broken the machine wont engage in the spin cycle so it isn't an expensive part to replace that could be worth checking. A volt meter would quickly tell you if it was working or not it is just a basic switch the other problem that happens is that the pump is blocked i.e. some hair and may need cleaning. They stop if they are blocked. I think they have a sensor, but once unblocked they are fine. So that is a couple of ideas to start with.
Thank you for contacting Fixya.com
170 views
Usually answered in minutes!
×